Using your Silentio™ Kettle
Before using your kettle.
It is recommended that you clean your kettle before use by filling the kettle with water, up to the maximum level indicator, boil and discard.
Using your kettle.
1.To fill the kettle, remove it from the power base and lift the lid, by pressing the button on the handle. Alternatively, the kettle may be filled through the pouring spout.
2.Fill the kettle with the desired amount of water. Always fill the kettle between the minimum and maximum marks. Too little water will result in the kettle switching off before the water has boiled.
6.Lift the kettle from the power base and pour the water.
NOTE: Use caution when pouring the water from your kettle, as boiling water will scald.
7.The kettle may be stored on the power base while not in use. The kettle will not
NOTE: Ensure the power is turned off at the power outlet when the kettle is not in use. Should you accidentally allow the kettle to operate without water,
NOTE: Do not fill the kettle over the maximum level, as water may spill out of the spout when boiling.
3.Push the lid closed firmly until it locks into position.
4.Place the kettle on the power base and connect the plug into a 230/240 Volt AC power outlet. Turn the power ON.
5.Press the ON/OFF button downwards at the base of the kettle. The ON/OFF button will illuminate to indicate the kettle is heating. The kettle will switch off automatically once the water has boiled.
NOTE: Ensure that the ON/OFF switch is clear of obstructions and the lid is firmly closed. The kettle will not turn off if the ON/OFF switch is constrained or if the lid is left open. Do not remove the kettle from the power base while water is heating.
Cord Storage Facility.
Excess cord can be stored by winding the cord around the storage facility underneath the power base.
360° power base
5
