Sunbeam KE9600 manual Before using your kettle

Using your Cafe Series® Variable Temperature Kettle

Before using your kettle.

It is recommended that you clean your kettle before using it by filling the kettle with water to the maximum level indicator, boiling the water and discarding.

Important: Do not fill the kettle over the maximum level, as water may spill out of the spout when boiling.

1.To fill the kettle, remove it from the power base and lift the lid, by pressing the button

at the top of the handle. Do not fill the kettle below the 'min' indication.

2.Fill the kettle with the desired amount of water. Always fill the kettle between the minimum and maximum marks. Too little water will result in the kettle switching off before the water has boiled.

3.Push the lid closed firmly until it locks into position.

4.Place the kettle onto the power base. Plug the power cord into a 230-240 Volt AC power outlet and switch the power on.

Note: If the kettle is not positioned on top of the power base correctly the LCD panel will show “--:---“.

Using your Cafe Series® Variable Temperature Kettle

Tip: The Variable Temperature Kettle has five optimum tea temperatures you can select from: 80°C, 85°C, 90°C, 95°C and 100°C (boil). Refer to the ‘Tea Brewing Styles and Tips’ table on page 8 for the ideal water temperature for your tea.

Note: The temperature settings are a guide only and may vary depending on personal preference.

1.Press the ‘TEMP’ button to select from five pre-set temperatures: 80°C, 85°C, 90°C, 95°C and 100°C (boil). Your selected water temperature will be displayed on the LCD display for 3 seconds. Press ‘START/ CANCEL’ to initiate the heating cycle.

Note: If after 3 seconds nothing is pressed, the LCD display will revert back to showing the current water temperature.

Note: If the START/CANCEL button is pressed without any temperatures being selected beforehand, it will automatically default to the last used setting. The START/CANCEL button is originally preset to 100°C (boil).

2.When the heating cycle is initiated, the LCD display will show the maximum amount of time required to reach the selected water temperature. The Time to Boil feature shown on the LCD display will count down and flash until the correct time is calculated. Once the correct time is calculated the Time to Boil recalibrates to the correct time remaining and will no longer flash.

5