Sunbeam LC3200 Fitting/using the tools on your Oskar Mini, Placing the spindle, Processing blade

Fitting/using the tools on your Oskar™ Mini

Note: All attachments must be firmly attached to the spindle. Always adjust the attachments until you are sure that they are correctly fitted.

Placing the spindle

1.Fit the spindle onto the drive shaft and ensure the blade locks into place, see figure 4.

Warning: Use caution, as blades are sharp. Always handle the processing blade by its central plastic section.

4.Place food into the processing bowl.

5.Fit the processing cover to the processing bowl, see figure 3 and place the food pusher in the feed tube.

6.Plug the power cord into a 230-240V AC power outlet and turn the power ‘ON’.

7.Start processing using the On/Off or Pulse buttons.

8.When processing is complete, remove the spindle and blade from the processing bowl before removing the processed food.

Fig 4

Processing blade

1.Fit the processor bowl and spindle as detailed previously in figures 1, 2 & 4.

2.Fit the processing blade over the spindle and press firmly into place, see figure 5.

Fig 5

11