Sunbeam LX SHOT OF STEAM Feature, VERTICAL STEAM Select models only, To Use VERTICAL STEAM

SHOT OF STEAM® Feature

•The SHOT OF STEAM® feature provides an extra burst of steam for deep penetration of stubborn wrinkles. The SHOT OF STEAM® feature can be used with dry or steam ironing provided the tank is at least 1/4 full of water and the temperature dial is set within the steam band.

•Place the iron on top of the wrinkle and press the SHOT OF STEAM® button each time you would like an extra burst of steam. THE SHOT OF STEAM® feature can be used continuously with just a short pause between shots.

VERTICAL STEAM (Select models only)

• The vertical steam feature allows your iron to function as a garment steamer.

TIP: When using the vertical steam on clothing, hang the clothing on a clothes hanger for best results. Hanging curtains and drapes may also be steamed.

To Use VERTICAL STEAM:

1.Make sure that the iron has heated up (2 minutes).

2.Hold the iron in a vertical position, with the iron close to but not touching the fabric you want to steam.

3.With your other hand, pull the fabric tight.

4.Press the SHOT OF STEAM® button in approximately 3-second intervals as you move the iron across the wrinkled area.

WARNING: To prevent the risk of burns, keep your hand away from the area being steamed.

DO NOT steam garments while wearing them; this may result in injuries.

SPRAY MIST® Feature

(Some Models Only)

•Use the SPRAY MIST® feature to dampen fabrics with stubborn wrinkles.

•Press the gray SPRAY MIST® button firmly to produce spray.

MOTION SMART® Auto Off Feature (Some Models Only)

• When the iron is plugged into 120 volt AC electrical outlet, the steady red light signals that the iron is plugged in and is ready to be turned on.

•If the iron is left on the heel rest unmoved the iron will stop heating in

15 minutes. The light on the handle will blink to indicate the iron has automatically shut off and will continue blinking until the iron is restarted or unplugged.

•If the iron is left unmoved in the ironing position or accidentally tipped over, the iron will stop heating in 30 seconds. Again, the light on the handle will blink to indicate the iron has automatically shut off and will continue blinking until the iron is restarted or unplugged.

NOTE: If the temperature dial is turned to the OFF position, the light will continue blinking and then go off.

•To restart the iron, move the iron back and forth. Allow the iron to heat and continue ironing as normal.

◆7