Sunbeam LX instruction manual Maintenance

• Pull cord firmly to unwind.

• Press winding button to reset device, then pull cord.

• Pull out the cord once and wind cord evenly on the reel.

◆9

• The water tank must be at least 1/4 full.

• The variable steam dial must be set on DRY until the iron is hot

SHOT OF STEAM® feature • The water tank must be at least 1/4 full.

does not work• Temperature must be set to steam position.

• The water tank may be empty. Turn steam valve to DRY and add water.

RESOLUTION

• Iron gives off an odor when turned on for the first time. Allow ten minutes for odor to disappear.

• Iron should be plugged into a 120 volt, AC electrical outlet only.

Maintenance

Other than the recommended instructions in this pamphlet, no further maintenance is necessary. However, following is a list of frequently asked questions and their resolutions. If for any reason your iron continues to exhibit one of these symptoms, or requires repair for another reason, send it to the Sunbeam Appliance Service Center or call our Consumer Hot Line 1-800-597-5978.

SYMPTOM

Iron emits an odor

Iron does not heat

•The temperature dial must be set at the desired temperature.

•The auto shut-off feature may have been activated (Some Models Only). Move the iron back and forth to restart.

Iron does not steam

•Allow iron to heat, then set the steam dial to one of the steam settings. Use temperature settings within the steam band.

•There may be an obstruction. Remove steam valve by turning it to CLEAN. Replace and set the steam dial to one of the steam settings.

•Iron should be in the horizontal position.

•Prime pump briefly.

•Allow a short pause between shots.

•Be sure to fully depress the SHOT OF STEAM® button.

SPRAY MIST® feature does not work

Iron is leaking

•The temperature setting is too low to produce steam (See Ironing Guide)

Cord will not pull out

Cord does not retract