Using your Eco Mop (continued)
Using the steam jet nozzle
1.Attach the steam jet nozzle by pushing it firmly onto the end of the mop.
2.Follow steps 3 to 9 on page 7.
Note: The nozzle can be rotated to angle the steam jet in the desired direction.
Using the squeegee
Before attaching the squeegee, fit the steam jet nozzle as described on page 8, ensuring that the steam hole is facing downward.
1.Attach the squeegee to the mop by aligning the hole in the end of the attachment with the
end of the mop. Depress the button to allow the attachment to fit over it. Push the attachment onto the mop until it is securely in position and the button pops out locking the attachment in place.
2.Follow steps 3 to 9 on page 7.
Note: Ensure that the squeegee is fitted over the nozzle so that the nozzle hole is visible from the underside of the squeegee.
Figure 12
Using the round brush
1.Attach the round brush to the mop by aligning the hole in the end of the attachment with the
the attachment onto the mop until it is securely in position and the button pops out locking the attachment in place.
2.Follow steps 3 to 9 on page 7.
Note: Do not use on coarse surfaces such as tile grout or cement for extended periods as this may damage the bristles.
Upright use
When using the mop for cleaning elevated areas (such as windows), only half fill the tank with water.
1.Ensure the mop is turned on at the outlet.
2.Hold the mop in the elevated position and move the steam on/off switch to the on position ( ) once the steam ready light goes out.
Figure 13
Note: Allow approximately 30 seconds for the steam to generate when the mop is in the upright position. If the mop fails to produce adequate steam when upright, gently shake it to reposition the weighted tubing inside the water tank so that it can draw water more efficiently.
3.Follow steps 6 to 9 on page 7.
9
