Using your Sunbeam Travel Iron (Continued)
Dry ironing
Follow steps 1 to 3 on page 6 under "Using your iron".
4.Select DRY on the STEAM/DRY dial. This will cut off the steam flow if there is water in the tank.
Steam ironing
Follow steps 1 to 3 on page 6 under "Using your iron".
NOTE: When steam ironing, ensure that the temperature dial is set to the three dot (•••) temperature setting, and that the tank is at least ¼ full of water.
4. Select STEAM on the STEAM/DRY dial.
Using the shot of steam
The shot of steam can be used when dry or steam ironing, when the temperature dial is set to the three dot (•••) temperature setting.
1.Ensure the tank is at least ¼ full of water.
2.Select the three dot (•••) temperature setting and wait until the thermostat light goes out.
3.Press the shot of steam button several times with the iron on the soleplate to prime the pump.
NOTE: If the tank has run dry, it may be necessary to
After each use
1.Turn the STEAM/DRY dial to DRY.
2.Turn the power off and remove the plug from the power outlet.
3.Empty any remaining water from the water tank.
4.Allow the iron to cool before winding the cord around the soleplate or placing it in the travel pouch.
Storage
Always store the iron on its heel rest.
Figure 3
NOTE: Do not store the iron with the soleplate facing down, or in the carton.
Cleaning
To clean the exterior of your iron, wipe over with a damp soft cloth and wipe dry.
Caution: Do not use harsh abrasives, chemical cleaners or solvents to clean the exterior of your iron as these will damage the surface.
Cleaning the non-stick soleplate
The
Wipe the soleplate with a damp soft cloth after each use. If polyester has burnt to the soleplate, iron a damp cotton cloth while hot.
Caution: Do not use scouring pads, abrasives or harsh cleaners to clean your
To clean the steam holes
To remove build up from the steam holes which may affect steam performance, use a cotton wool tip moistened in methylated spirits.
7
