Using your Sunbeam Accura® Iron (continued)
Using the shot of steam
The shot of steam can be used when dry or steam ironing.
1.Ensure that the tank is at least ¼ full of water.
2.Select the desired temperature using the +/- buttons.
Note: The Accura iron’s twin element construction allows you to iron with maximum steam, even on low temperature settings.
3.Press the shot of steam button several times with the iron on the soleplate to prime the pump.
Note: If the water tank has run dry, it may be necessary to
Using the spray mist
The spray mist can be used when steam or dry ironing to
1.Ensure that the tank is at least ¼ full of water.
2.Press the spray button during ironing to release a fine mist from the spray nozzle.
The 3 way safety auto-off feature
For total safety and peace of mind, the iron will automatically switch itself off if left unattended. It will switch off if left in the ironing position for 30 seconds, or if it is knocked onto its side. It will also switch off if left unattended in the upright position for 15 minutes.
15 mins
30 seconds
Should you leave the iron unattended, the red light located between the +/- temperature buttons will flash and a warning beep will sound to alert you that the
Figure 6
Power to the iron’s heating element will be cut and the iron will start to cool.
To reset the safety
After 30 seconds the frequency of the beep alarm will decrease.
Abnormal digital function
If you find that your iron is incapable of steaming or that the temperature control buttons have become inoperable, a fault has occurred. In the event of a fault, the red temperature alert light located between the +/- temperature buttons will flash. To reset the iron, simply switch it off at the power outlet. The iron can then be switched on again and should operate normally. If the fault persists contact the Sunbeam Consumer Service line.
Figure 5
9
