9
HeadingCare and CleaningHelp Line
If you have any additional questions about using the BRITA® Water Filter & Chiller, please call the
Sunbeam help line in Australia on 1800 025 059. In New Zealand, please call 0800 786 232.
• Do not use harsh detergents or abrasive
cleaners.
• Do not place any part of this appliance in a
dishwasher
• Wipe the base with a clean cloth or paper
towel.
• Wash the filtering tank in warm, soapy water
using a mild detergent.
• Wipe the inside of the filtered water tank
with a damp cloth which has been soaked
in soapy water.
• Do not immerse the base in water or any
other liquid.
• If the unit is to be moved or stored for a
prolonged period of time without being
used, we recommend that you drain the
internal tank of any water.
• Before using the water filter & chiller
again take out the BRITA Maxtra water
filter cartridge, clean the water tank and
repeat the steps as described on page 6
(“Preparing the BRITA Maxtra filter catridge
for use”).
Emptying the internal tank
• Switch off the appliance and unplug from
the mains
• Remove the lid and the filtering thank and
any water in the filtered water tank.
• Turn the appliance upside down to reveal a
drain plug located in the centre of the base.
• Using a $2 coin or a suitable screw driver,
turn the plug anti clockwise until it is fully
loosened. Please note that it cannot be
completely removed.
• Drain the tank.
• Insert the plug after draining and using
a $2 coin or suitable screwdriver, turn it
clockwise until it stops.
• Do not over tighten as this may damage the
plug.
For BRITA® filter cartridge and Memo
queries, contact BRITA® Consumer Care.
Australia
1300 557 762
New Zealand
0800 427 482