Sunbeam WF6000 manual Using your Water Filter & Chiller

Using your Water Filter & Chiller

Before using your Water Filter & Chiller

•Carefully unpack the appliance and check that all the components are included.

•Remove the filter cartridge and keep in a safe place.

•Remove the lid and filtering tank and wash in warm soapy water, rinse and wipe dry. Do not re-insert until (a) flushing process and (b) preparation of filter cartridge procedures, as explained below, have been completed.

•Wipe out the filtered water tank with a damp cloth which has been soaked in water.

•Position the appliance on a dry, level and secure bench top. Allow a good airflow around the appliance so do not place directly against a wall.

•It is important that you flush and rinse out the dispensing system before using the appliance for the first time.

•Fill the water tank to the brim with hot tap water.

•Place a large container or jug under the spout.

•Press the dispenser lever until all the water is dispensed and the water tank is empty.

•Repeat this flushing process twice with cold tap water and discard.

•Please note that when flushing for the first time, while pressing the dispensing lever, no water will be dispensed until the tank is almost empty as it will be filling the chilling tank.

•Do not fill above the maximum level indicated.

•Please note that you should carry out these steps without the Maxtra cartridge in place.

•Plug the appliance into an appropriate electrical outlet and switch on.

•A white power on light will be illuminated to show that the appliance is switched on and working.

6