SunBriteTV SBWM46NA manual Cover Plate Installation, Installing Interface Brackets to Display

Installation Instructions		SB-WM46
Cover Plate Installation
1.	Install four cover plates (T) using four 10-32 x 1 1/8" Phillips
	pan machine screws (V) and four spacers (W). Insert screw
	into cover plate and add the spacer before inserting the
	cover plate tab into the arm assembly/wall plate. (See
	Figure 3)
	2	x 4
	Place tab
	into slot
	(T) x 4
	(W) x 4
	Figure 4
	level with top of washers	(46" or 55" models)

Figure 3

Installing Interface Brackets to Display

1. Place display face down on a soft, non-abrasive surface.

2.Remove four sets of bolts and washers that were shipped

attached to the back of the display. Set hardware aside for re-use. (See Figure 4)

WARNING: The bolts and washers are designed to be
permanent fixtures on the television. Never remove the bolts	(D) x 2
or washers except for installation of the wall mount! Always		just above rubber sealing gasket
replace bolts immediately. Installing the television without the	level with top of washers		(65" models)
bolts and washers may result in serious personal injury and/
or damage the television!

3.Place interface brackets (C or D) on the back of the display

so that they align with the holes on the display. Use removed screws and washers to loosely attach interface brackets to display. (See Figure 5)

NOTE: Use short brackets (D) if installing to 46" or 55" models and long interface brackets (C) if installing to 65" models.

4. Align bottom of the brackets with rubber sealing gasket and the top of the brackets with the top of the washer. (See Figure 5)

(C) x 2 just above rubber sealing gasket

Figure 5

7