Page 14
7.0 Spa Fill Up procedure
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY
BEFORE PROCEEDING WITH THAT STEP.
1. prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially
formulated spa cleaner. Consult your authorized Sundance
dealer for additional information prior to filling spa.
• Remove filter/skimmer lid (page 20), then remove filter cartridge
as outlined in section 11.1 (page 25).
2. Fill Spa
• Place the end of your garden hose into the empty filter bucket.
CAUTION: Never fill with water from a water softener. If your
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. Or,
you may fill entirely with hard water if you use a special water
additive available from your authorized Sundance dealer.
• Fill spa with clean tap water from garden hose until water covers
all jets (DO NOT OVERFILL!)
ImpORTANT: Always fill your spa through the filter bucket
after draining. Failure to do so may cause air to be trapped
in either pump, preventing the pump from circulating water.
Remove the hose and replace the filter cartridge. Note: DO
NOT overtighten filter cartridge, finger tight only!
3. Turn On power
Turn on power to spa at the home’s circuit breaker. The heater
and filter pump will automatically activate. If the control panel LCD
flashes water temperature and “COOL” or “ICE”, refer to page 31 for
additional information.
4. Activate Jets pump 1
Depress the JETS 1 button on the control panel once
to activate jets pump #1. On Burlington models, press
JETS 2 button to activate jets pump #2.