5 ADD START-UP CHEMICALS
Add the hot tub water chemicals as recommended by your Sundance
Dealer. (See the section titled WATER QUALITY MAINTENANCE (page 28) for
general guidance.)
6. SET HOT TUB TO HEAT
To w arm the hot tub water up to a comfortable temperature, follow these
steps:
•The LCD display on the control panel displays the actual temperature of
the hot tub water. Press either the COOLER(Down) or WARMER (Up)
sensor pad to display the “set” temperature for 5 seconds. If you want
the water to heat to a different temperature, simply press COOLER or
WARMER within 5 seconds. The set temperature advances or decreas-
es by one degree each time one of these sensor pads is pressed.
• The heater will turn off when the temperature corresponding to the ther-
mostat setting is achieved.
NOTE:
• The maximum temperature for which the hot tub can be set is 104˚F (40˚C) and
the minimum is 80˚ F. (27˚C)
• Setting the thermostat at maximum will not accelerate the heating process.
This will only result in a higher ultimate temperature.
• If hot tub is hooked up to 30 amps - turn off high speed pump and blower
to operate heater.
7. PLACE COVER ON HOT TUB
• Keeping the insulating cover in place anytime the hot tub is not in use
will reduce the time required for heating, thereby minimizing operating
costs.
• The time required for initial heat-up will vary depending on the starting
water temperature and the capacity of your hot tub. Smaller hot tubs
heat at a rate of approximately 8 to 10 degrees per hour; larger hot tubs
heat at about 4 to 6 degrees per hour.
DANGER. RISK OF INJURY. Always check water temperature carefully
before entering hot tub.
Page 14