I X . S E T - U P , A D J U S T M E N T & U S E
I X . S E T - U P , A D J U S T M E N T & U S E
F. REMOTE JOYSTICK
INSTALLATION
1.To Connect
a)Line up female cylindrical connector
(C) with its male receptacle on the end of the power cable (D).
b)Push in firmly.
2.To disconnect
Pull back on the retaining ring of the cylindrical connector (C) until it disconnects from the power cable (D).
G. TO ADJUST THE HEIGHT OF THE REMOTE JOYSTICK
a)Remove the two
b)Remove the joystick from the mount by unfastening the two screws (C) on the underside of the mount.
c)Position angle bracket mount such that you achieve the desired joystick height. Four positions are available by relocating the mount either on the top or bottom of the mounting bar (D) and/or by rotation of the angle bracket mount.
H.REMOTE JOYSTICK SWING-AWAY RETRACTABLE MOUNT (OPTIONAL)
The joystick is mounted with a mechanism which allows the control to be locked in a forward or retracted position.
1.Adjustment
a)To retract joystick, press firmly on inside of joystick (E).
b)Push joystick away from front of armrest until it locks into retracted position.
c)To return to forward position, pull to release magnetic catch and swing.
d)Tension adjustment can be made by tightening through bolt (F).
D
C
BA
C
D
E
F
I.FLIP BACK WIDTH ADJUSTABLE ARMRESTS (CONTOUR & HIGH BACK CONTOUR SEAT)
1.Installation/Removal or Adjustment
a)Insert armrest support (A) inside of 1" square tube (B) located on back of the seat.
b)Repeat for other side of seat.
c)Position armrest at appropriate width.
d)Tighten set screws (C) on square tube using allen wrench.
J.ANGLE ADJUSTMENT ARMRESTS
1.Adjustment
a)Flip back armrest.
b)Adjust the angle of the armrest by turning the bolt (D) clockwise to reduce the angle and counter clockwise to increase the angle.
c)Fully tighten the jam nut.
K.
(SEAT FRAME ONLY)
The
1.Installing Armrest
a)Flip levers A and B to open receivers.
b)Insert front and rear armrest posts into receivers.
c)Flip levers A and B to engage.
2.Set-up for Flip-back Operation
a)Flip lever A so front post is able to lift free.
b)Armrest now has the ability to be flipped back without removal.
3.Set-up for Removal
a)Flip levers A and B so front and rear posts are able to lift out freely.
b)Armrest can now be easily removed for transferring.
4.Height-Adjustment
a)Release the upper securing lever (C).
b)Set at desired height
c)Return securing lever to locked position.
d)Move armrest up or down to allow armrest to snap into place.
C
A
B
D
B
A
C
930484 Rev. A | 30 | 31 | 930484 Rev. A |
