Component Racking Connector
User Instructions
Model
IMPORTANT WARNINGS
Inspect all parts for damage to the carton or its contents. If damage is evident, do not use. Contact your local Sunrise Medical dealer immediately.
Read all instructions before using this product. Failure to follow these instructions may result in injury or damage.
Make sure all attaching hardware is tightened securely at all times.
The recommended weight capacity of the component racking connectors is 150 lbs.
INSTALLATION
1. Disconnect head and foot springs from bed assembly. For complete instructions, refer to Bed Instruction Manual
2.Connect the head and foot ends by inserting the pins of the rail connectors into the hooks of the
bed ends (Figure 1). | Figure 1 |
| |
|
|
3. Use the flat head screws and hex nuts provided to fasten the rail connectors to the head and foot ends. Make sure the hex nuts are placed on the inside of the rail connectors.
4. Place head and foot springs upright across the rail connectors between the bed ends (Figure 2).
Figure 2
