Sunrise Medical P-220 instruction manual Folding Backrest, Elevating Legrest Optional

30 I X . S e t - U p , A d j u s t m e n t & U s e

C. FOLDING BACKREST

Quickie P-220 wheelchairs are shipped with backrest in folded position.

1.Upright Positioning

a.Lift backrest to upright position so that latch handles (A) lock into place.

b.Backrest is ready for use.

2. Folding Backrest A

a. Lift and turn backrest latch handles (A) inward or outward.

b. Fold backrest forward.

I X . S e t - U p , A d j u s t m e n t & U s e		31
E	ELEVATING LEGREST (OPTIONAL)
1.	Installation
To install or remove Elevating Legrest (ELR) see instruc-		new drawing
tions for Swing-away Footrest installation page 28.
2.	Adjustment
	a. To raise legrest, lift to desired position. Legrest	G
	will automatically lock in place.
	b. To lower legrest, while seated in chair, first lift
	slightly then press release lever (G) down and
	lower legrest to desired position.

F. INTEGRAL JOYSTICK INSTALLATION

CAUTION: Backrest latches must be locked into place before operating wheelchair.

D. SWING-AWAY FOOTRESTS

1.Installation

a.Place swing-away pivot pin (B) into the locating hole (C) on top of the hanger mount with the footrest facing outward from frame.

b.Rotate the footrest inward until latch plate locks

(D)into place on locking bolt.

2.Removal

a.To remove footrest, press quick-release lever (E).

b.Rotate footrest outward and lift.

3.Height Adjustment

a.Remove both bolts (F) in the hanger frame tube.

b.Reposition footrest height.

c.Re-tighten all bolts (F).

B

C

D

E

F

1.To Connect

a.Align beau plug (A) with its receptacle below seat on front of power drive unit.

b.Push in firmly.

2.To Disconnect

Pull forward firmly on the beau plug (A) until it disconnects from receptacle.

G.REMOTE JOYSTICK INSTALLATION (OPTION)

1. To Connect

	a. Line up small cylindrical connector with its
	receptacle on the rear of the joystick.
	b. Push in firmly.
2.	To disconnect
Pull back on the retaining ring (H) of the cylindrical
connector until it disconnects from the joystick box.			H
H. TO ADJUST THE HEIGHT OF THE REMOTE JOYSTICK
	a. Remove the two pan-head screws (A), securing
	the angle bracket mount (B).
	b. Remove the Joystick from the mount by unfas-
	tening the two screws (C) on the underside of
	the mount.
	c. Position angle bracket mount such that you	B	A
	achieve the desired joystick height. Four posi-
	tions are available by relocating the mount	C
	either on the top or bottom of the mounting bar
	(D) and/or by rotation of the angle
	bracket mount.
			D

930475 Rev. A

930475 Rev. A