40 | X . O p e r a t i n g G u i d e |
X . O p e r a t i n g G u i d e
41
E. INTEGRAL JOYSTICK | D E |
| |
The standard integral joystick controls the chair’s per- |
| ||
F |
| ||
formance. It consists of the following parts: | B | G | |
1. Speed Control or Drive Mode Selection Buttons |
| H | |
(A and B) | C | ||
| |||
To decrease the speed level depress button A. Or, when | A |
| |
1- 5 Drive modes are programmed, depress button A to |
|
| |
activate lower drive mode(s). |
|
| |
To increase speed level, depress button B. Or, when 1- |
|
| |
5 Drive modes are programmed, depress button B to | Integral Joystick |
| |
activate higher drive mode(s). |
| ||
|
|
Speed level active, or Drive Mode selected, is indicated on display (C) by a series of five lights. One light indi- cates slowest level/mode currently active, while five lights indicates highest level/mode currently active.
2.Battery Charge Indicator (D)
•Green lights indicate that batteries are fully charged.
•Yellow lights indicate that batteries need recharging.
•When the lights stay in the red band, the batter- ies must be recharged.
3.On/Off Button (E)
Turning the chair on or off is accomplished by depress- ing button E.
4.Horn (F)
5.Joystick (G)
The joystick controls the direction and speed of your chair. Turn the chair on and move the joystick in the direction you want to go.
•Moving the joystick from the neutral (center) position disengages the motor locks, allowing the chair to move.
•The chair will move faster the more you move the joystick away from neutral.
NOTE– If your speed becomes hard to manage, release the Joystick and the chair will come to a com- plete stop.
•When you release the joystick it will return to neutral; the chair will slow to a stop and the motor locks will reengage.
•We recommend that you switch the chair off if you stop for any length of time. This will con- serve battery power.
NOTE– Once the chair stops, switching the chair off will not affect the motor locks.
6. Joystick Boot (H)
Make sure the boot is not torn or cracked (this could allow debris, water or moisture to enter). If the boot is torn or cracked, replace it as soon as you can.
F. REMOTE JOYSTICK ASSEMBLY (OPTIONAL)
The remote joystick connects to a controller, which controls the chair’s performance. The joystick assembly consists of the following parts:
1. Speed Control Knob (D)
Use the speed control knob to adjust the maximum speed of your chair. Turn it
2.Battery Charge Indicator (B)
•Green lights indicate that batteries are fully charged.
•Yellow lights indicate that batteries need recharging.
•When the lights stay in the red band, the batter- ies must be recharged.
3.On/Off Mode switch (A)
The on/off mode switch is located on the rear face of the joystick housing. It is a toggle switch. Turning the chair on or off, is accomplished by pressing the switch downward. The switch will automatically return to the center point. Alternate locations exist for this switch. Please see your supplier in the event that you wish to relocate or
4. Mode Switch (A)
The on/off mode switch allows you to select from 5 (five) different programmable drive profiles or actuator mode sets.
| E | |
B | F | |
D | ||
| ||
G |
| |
| H | |
| A |
Remote Joystick (Optional)
930475 Rev. A | 930475 Rev. A |
