Sunrise Medical P-222SE instruction manual O p e r a t i n g G u i d e

12 V I . O p e r a t i n g G u i d e

V I I . M a i n t e n a n c e & T r o u b l e s h o o t i n g T i p s 13

TO OPERATE THE C.G. TILT

A. TOGGLE SWITCH ACTIVATION
1.	To operate, push the toggle switch (A) forward
	(to tilt back) or pull toggle backward (to return
	to neutral) until tilted into the desired posi-
	tion.
2.	The toggle switch will return to neutral when
	released and the seating system will stop moving.

A

A. MAINTENANCE

You should check the items on this chart at the indicated intervals. If any of the items are loose, worn, bent or distorted, immediately have them checked and/or repaired by your authorized Sunrise supplier. Frequent maintenance and servicing will improve per- formance and extend wheelchair life.

NOTE– Check weekly, and use a clean, dry cloth or compressed air as needed to keep glide bearings free of debris.

B. SINGLE SWITCH ACTIVATION
1.	Depress and hold single switch to tilt
	back into the desired position.
2.	Depress and hold single switch to return to
	neutral until tilted into the desired position.
C. INTEGRAL JOYSTICK ACTIVATION (OPTIONAL)

From the “off” position:

1.Push the on/off button (A) once to turn the chair on.

2.Push either tilt button (B or C) to activate tilt mode.

3.Push forward on joystick (D) to tilt back.

4.Pull backward on joystick (D) to tilt forward.

5.Push either tilt button (B or C) to deactivate and resume drive mode.

D.REMOTE JOYSTICK ACTIVATION (OPTIONAL)

From the “off” position

1.	Push the on/off mode select toggle switch (A)
	down once to turn the chair “on”.
2.	Push the on/off mode select toggle switch (A)

A

B

D

C

C

B

CHECK...

Charge Batteries

Glide bearings free of debris

Check tires for proper inflation level

Check batteries for proper electrolyte level (wet cell only)

Check plugs and connectors for proper connections

Check all moving parts for wear

Inspect all nuts, bolts and fasteners for looseness or wear

Inspect upholstery for wear

Remove and inspect motor brushes

Servicing by authorized Supplier

Check front mount bolts for looseness

Check actuator limit switch position

Check front mount for excessive wear

B. TROUBLESHOOTING TIPS

Daily Weekly Monthly	Quar	Annually
	terly

✓

✓

✓

✓

✓

✓

✓

✓

✓

✓

✓

✓

✓

	up twice to move index to tilt mode (noted by
	two (2) actuator lights (B)).
3.	Push the joystick (C) forward to tilt backward or
	backward to tilt forward.
4.	Push the on/off mode select toggle switch (A)
	up once to return to drive mode.
E. SPECIALTY DRIVE CONTROLS (OPTIONAL)

Please refer to your QTRONIX USCM User Instruction Manual.

CAUTION– The power base drive lock-out feature will activate and the chair cannot be driven if the seating system is tilted more than 20°.

A

If you should notice your C.G. Tilt system binding up, not running in a smooth fash- ion, or emitting an unusual noise during use, a foreign matter may have come into contact with the glide bearings. If this occurs, use a clean, dry cloth or compressed air to clear or, if needed, please see your authorized Sunrise supplier.

If your tilt system will not function, check to ensure the tilt lock-out sensor is seated properly in its mount. The wires should lead out of the sensor toward the front of the chair.

930478 Rev. A 930478 Rev. A