Sunrise Medical Quickie 2 Lite Fixed Front Footrest Height Adjustment, Replacing Armrest, Removal

D. HEIGHT-ADJUSTABLE ARMRESTS (OPTIONAL) 6 6a

1.Installation

a.Slide the outer armpost into the receiver mounted to the wheelchair frame.

b.The armrest will automatically lock into place.

2.Height Adjustment

a.Rotate release lever to second stop.

b.Slide armrest pad up or down to desired height.

c.Return lever to locked position against armpost.

d.Push arm pad until upper armpost locks firmly into place.

3.Removing Armrest

a.Rotate release lever to first stop and remove the armrest.

4.Replacing Armrest

a.Slide armrest back into receiver.

b.Return release lever to locked position against armpost.

5.Adjusting Armrest Receiver Fit

To tighten or loosen the fit of the outer armpost in the receiver:

a.Loosen the bolts on the sides of the receiver.

b.With the armrest in the receiver, squeeze the receiver to achieve the desired fit.

c.Tighten the four bolts.

				I X .
	4		6
6			2
			5
	1		3
	7	9	7	6a
1.	Outer armpost			8
2.	Release Lever–
	Height		9
3.	Release lever
4.	Armrest pad
5.	Transfer bar
6.	Side panel
7.	Receiver
8.	Clamp
9.	Receiver adjustment
	hardware

E.SWING-IN/SWING-OUT HANGERS AND FOOTRESTS (70º, 80°)

1.Installation 7

a.Place swing-in/swing-out pivot saddle into the receiver on front frame tube with the footrest facing outward from the frame. ( 7 -A)

b.Rotate the footrest inward until it locks into place on locking bolt. ( 7 -B)

2.Removal

a.To remove footrest, push release latch toward the frame.

b.Rotate footrest inward and lift. Or, pull footrest away from frame and rotate outward.

3.Height Adjustment 8

NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the footrest and the floor.

a.Loosen set screw (C) using a 3/16 inch hex key.

b.Slide footrest extension up or down inside frame tube to desired height.

c.Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).

F. FIXED FRONT FOOTREST HEIGHT ADJUSTMENT 9

Using a 3/16 inch hex key, loosen the screw (D) on both sides of the footrest. Slide the footrest up or down to the new desired height and tighten the two screws back into place. Use a torque setting of 144 in-lbs (16.27 Nm). It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the footrest and the floor. Additionally, both sides of the footplate should be of equal height. This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.

NOTE– Footrest must be in locked position before riding in wheelchair.

7

A

B

8

C

9

D

108590 Rev. A 14