SBA-7142G-T4 Blade Module User’s Manual

5-8

Super IO Device Configuration

The menu options in the SUPER IO CONFIGURATION submenu and their descriptions are

shown in Table 5-6.

Remote Access Configuration

The menu options in the REMOTE ACCESS CONFIGURATION submenu and their

descriptions are shown in Table 5-7.

Table5-6. Super IO Configuration Submenu

Menu Option Description
Serial Port1 Address
This option specifies the base I/O port address and Interrupt Request address of
serial port 1. The options are DISABLED, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3.
• Select DISABLED to prevent the serial port from accessing any system
resources. When this option is set to DISABLED, the serial port physically
becomes unavailable.
• Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address
and IRQ 4 for the interrupt address.
Serial Port2 Address
This option specifies the base I/O port address and Interrupt Request address of
serial port 2. The options are DISABLED, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.
Select DISABLED to prevent the serial port from accessing any system resources.
When this option is set to DISABLED, the serial port physically becomes
unavailable.
Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and
IRQ 3 for the interrupt address.
Serial Port 2 Attribute This option can set COM 2 as a normal serial port or virtual COM for SOL.
Options are COM or SOL.

Table5-7. Remote Access Configuration Submenu

Menu Option Description
Remote Access Allows you to Enable or Disable remote access. If enabled, the settings below
will appear.
Serial Port Number Selects the serial port to use for console redirection. Options are COM1 and
COM2*
Serial Port Mode Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8, N,
1), (38400 8, N, 1), (19200 8, N, 1) AND (09600 8, N, 1).
Flow Control Selects the flow control to be used for console redirection. Options are None,
HARDWARE and SOFTWARE.
Redirection After
BIOS POST
Options are DISABLE (no redirection after BIOS POST), BOOT LOADER
(redirection during POST and during boot loader) and Always (redirection
always active). Note that some OS's may not work with this set to Always.
Terminal Type Selects the type of the target terminal: ANSI, VT100 and VT-UTF8.