Installation Instructions -

FBK-100 or FBK 200 Blower Kits and JBK Junction Box Kit

IMPORTANT

All electrical wiring must be performed by licensed Elec- tricians. Electrical wiring must comply with the National Electrical Code ANSI/ NFPA 70 - latest edition

Step 1. Follow the instructions below for the model you are installing:

Model UVF-36:

Using a screwdriver remove the screw from the blower access panel as shown in Figure 18. Slide the panel to the right until the flange clears the opening. Remove the panel and set aside.

Models UVFRC-3628, UVFRC-3628-H, UVFRC-4228 & UVFRC-4228-H:

Lift out the bottom refractory panel (see Figure 17).

Step 2. Remove the rectangular knock-out (for J-Box) on the right side of unit (see Figure 8 for location). Install the Junction Box & Electrical outlet below the firebox floor into the rectangular opening on the right side cabinet panel where you removed the knock-out (see Figures 20 & 21). The Junction Box / Electrical Kit is sold separately (see Page 15 for ordering information).

Note: Pass the wires through the hole, then squeeze the J-Box flanges together to fit into opening.

Step 3. Loosely tie a knot in the power cord to take up slack (see Figure 22).

Cover Plate

J-Box &

Receptacle

Remove knock-out

(strain relief bushing presses into this hole around romex wires

-see Step 8 on Page 14).

Screw

Strain Relief Bushing

Figure 19 - Junction Box Kit (all models)

J-Box & Electrical Outlet

J-Box Flange

Firebox floor

Install into side wall rectanular opening

Figure 20 - Model UVFRC-4228 Shown

Step 4. Locate the tabs shown in Figure 23. Position the blower assembly so that the tabs (located on the cabinet base) are seated in the notches of the blower bracket. Bend the tabs over to secure the blower assembly (see Figure 24).

Step 5. Plug power cord into the electrical outlet as illustrated in Figure 15.

Lift Out Bottom Refractory Panel

J-Box Flanges

Right Outside Cabinet Panel

J-Box &

Electrical

Outlet

Models: UVFRC-3628, UVFRC-3628-H, UVFRC-4228 & UVFRC-4228-H

Figure 17

Firebox

 

Screw

floor

 

Blower

Access

Panel

Remove screw, then lift out blower access panel.

Figure 18 - Model UVF-36

Wires

Figure 21

NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.

13