Model UVFRC-4228 Shown

Firebox floor

Loose knot in power cord to take up slack

Figure 22

Model UVFRC-4228

Locating Tabs

Figure 23 - UVFRC-4228 Shown

Bend Locating Tabs Over

(into notches)

Figure 24 - UVFRC-4228 Shown

Step 6. Route a 3-wire, 120 VAC, 60 Hz, 1 ph power supply to the right side of appliance.

Step 7. Locate the J-Box cover (provided in J-Box Kit). Remove the round knock-out (see Figure 19).

Step 8. Ensure that power supply wires are NOT "live" before making these connections). Install J-Box Cover Plate as follows:

Feed the * Romex wires (or other equivalent plastic insulated wire

-Refer ANSI/NFPA 70 - National Electrical Code - Latest Edition) through the J-Box Cover retangular opening, then connect to the J-box wires. The strain relief bushing should be pressed into the knock-out on J-box cover around the Romex (this will provide protection to the wires and prevents strain against connections from J-box). See Wiring Diagram - Figure 16. Install the cover plate over J-Box opening on appliance as shown in Figure 25.

Note: Wire connections should be positioned inside of the ap- pliance.

*Romex is a plastic insulated wire from power supply - sometimes called non-metallic sheath.

Right Side Panel of Firebox

J-Box opening on appliance

Use screw provided and

The notched side of

secure in place as shown

cover plates goes inside

 

firebox panel

Screw

Cover Plate

Figure 25 - Installing J-box Cover Plate - All Models

Step 9. Follow the instructions below for the kit you are installing:

FBK-100Kits-Installafield-provided(orP/N85L87)ON/OFFwall switch in a convenient location on a wall, near the fireplace.

FBK-200Kits-Installthekit-providedvariablespeedcontrol(rheo- stat) in a convenient location on a wall, near the fireplace.

Step 10. Follow the instructions below for the model you are installing:

Model UVF-36:

Reinstall the blower access panel that was removed on Step 1 (see Figure 18).

Models UVFRC-3628, UVFRC-3628-H, UVFRC-4228 & UVFRC-4228-H:

Reinstall the bottom refractory panel that was removed on Step 1 (see Figure 17).

14

NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.