Manuals / SV Sound / Car Audio and Video / Car Speaker

SV Sound SB12-NSD, PC12-NSD Connectivity & Panel Operations, SV Sound, LLC, STA-400DEquipped Subs

Models: PC12-NSD

1 18

Download 18 pages 62.24 Kb

Page 8

Image 8

STA-400D Equipped Subs

SV Sound, LLC

Connectivity & Panel Operations

FIG. 4

Alternatively, especially for two-channel preamps that don’t have (or don’t use) any digital management, the typical connectivity scenario would be to use both the main channel Left and Right (L/R) inputs into the STA- 400D. In this case the subwoofer would sit between the main L/R low level outputs of the preamp and the L/R low level inputs of the STA-400D, with the L/R outputs of the STA-400D going to the inputs of the power amplifier for the system’s L/R main speakers. (see figure 5)

Page 8

Image 8

SV Sound SB12-NSD, PC12-NSD, PB12-NSD manual Connectivity & Panel Operations, SV Sound, LLC, STA-400DEquipped Subs

Contents

SV Sound, LLC Manual Version 1.4 JuneSTA-400DEquipped Subs Table of Contents Important Safety Instructions SV Sound, LLCImportant Safety Instructions SV Sound, LLCSTA-400DEquipped Subs WELCOMESV Sound, LLC STA-400DEquipped Subs About your SVS SubwooferSV Sound, LLC Input Configuration STA-400DConnectivity and Panel OperationInputs Connectivity & Panel OperationsSTA-400DEquipped Subs Connectivity & Panel OperationsSV Sound, LLC STA-400DEquipped Subs Connectivity & Panel OperationsSV Sound, LLC If you have one of SVS’s AS-EQ1 high-resolution, multi-subwooferEqualizers, see Figure 6 for proper connec- tivity with one or more subwoofers. Also refer to your AS-EQ1Operator Manual for detailed information on connectivity and setup of the AS-EQ1into your listening environment. see figure Connectivity & Panel OperationsSV Sound, LLC STA-400DEquipped SubsPower Mode Switch Power LEDPhase OutputsMain Power Switch Power CordGain Control Connectivity & Panel OperationsSetup, Calibration & Integration Power and Signal ConnectionUnpacking and Subwoofer Location SV Sound, LLCSetup, Calibration & Integration SV Sound, LLCCalibrating the Subwoofer Setup, Calibration & IntegrationSTA-400DEquipped Subs SV Sound, LLCSV Sound, LLC Setup, Calibration & IntegrationBefore starting, familiarize yourself with your AVR or pre/pro’s setup and configuration menu. Of particular importance are the menus dealing with setting up your speakers distance, level, size, crossover, etc.. Once you have read and feel comfortable with setting up your speakers, you are ready to begin Setup, Calibration & Integration eUsing the Manual Speaker Setup menu of your receiver or pre/pro, play the speaker level match- ing test tone and adjust each speaker to read 75 dB “5” on the meter with the range switch set to 70 using the speaker trim controls found in the menu for each channel. When playing the test tone for the subwoofer, use the Gain control on the STA-400Dto raise or lower the level of the subwoofer to read 75 dB leaving the subwoofer trim control in the AVR or pre/pro set to -3dB. Note the meter may fluctuate by several dB when measuring the subwoofer. This is normal and what you are seeing are room modes in play. Use the average of the swings to determine the volume of the subwooferSV Sound, LLC STA-400DEquipped SubsSV Sound, LLC Terms & ConditionsSV Sound, LLC 6420 Belmont Avenue, Girard, Ohio