SVAT Electronics CLEARVU3 instruction manual Troubleshooting, now you can see

SVAT ELECTRONICS

now you can see

3.Plug the camera’s power supply into the power jack located on the 60ft video/ power wire.

4. Plug the camera’s power adapter into an AC outlet.

5.Connect the 60ft video/ power wire’s male RCA plug to the VIDEO IN port of your TV/monitor/VCR/DVR.

6.If your VIDEO IN port is a BNC connection (common with DVR units), you will need to attach the BNC to RCA adapter before connecting the camera.

3

5

4

6

14.2.2 Troubleshooting

	-	Make sure your TV/monitor is on the correct video input
		channel. This is NOT channel 3. Common terms for this channel
		is INPUT, AV CHANNEL, LINE 1, LINE 2 and AUX. Please use
		your TV or VCR manual to correctly identify this channel.
No picture/signal	-	If your camera is connected to a VCR/DVR, make sure that
		it is properly connected to your TV/monitor.
	-	Check all connections to make sure they are secure and
		properly connected.
	-	Check your power supply to ensure that the camera is
		powered up.
	-	Make sure your camera is not aimed at direct sunlight.
	-	Adjust the sunshade by sliding it forwards to block out
Picture is too bright		excess light.
	-	Make sure nothing is obstructing the CDS sensor on the
		camera. If the CDS sensor is blocked, night vision mode will be
		active and may produce extra light in your camera’s picture.
	-	Move your camera to another location.
	-	If using at night, make sure your camera’s subject is
		no more than 15ft away (may vary based on amount of
		ambient light available).
	-	If using during the day, your camera may not be getting
		enough light. Adjust the sunshade by sliding it backwards to
Picture is too dark		let in more light.
	-	Check the brightness and contrast settings on your TV/monitor
	-	If your camera is connected to a VCR/DVR, check the
		brightness and contrast settings on the VCR/DVR
	-	Move your camera to another location.

CLEARVU3 49