Swann MicroCam II External antenna, Monitor or TV, Receiver, Video IN, To Audio and, 9v Battery Adaptor, Receiver, Receiver Features, Important Information about this product

Receiver Features

Important Information about this product

ActiveChannelLeds

Channel

Selector

Button

SEL CH4 CH3 CH2 CH1

External antenna

Monitor or TV

	Receiver	To Audio and
	Receiver	Video IN
		Video IN
		Audio / Video Out
		Receiver
		Power Adaptor
		DC Socket
		Loop / Normal Switch

!	DUE TO GOVERNMENT PRIVACY REGULATIONS RELATING TO THE USE OF
	COVERT LISTENING DEVICES IN SOME COUNTRIES, THE MICROCAM III
	TRANSMITTER SENDS VIDEO ONLY - IT DOES NOT HAVE AUDIO
	TRANSMISSION CAPABILITY WHERE THESE RESTRICTIONS ARE IN PLACE.
!	Best Results are achieved where there is a clear “line of sight” between the MicroCam III
	transmitter and Receiver.
!	Try to avoid obstacles such as trees, walls, cars, trucks and buildings when maximum range is
	required.
!	Interference from certain electronic equipment or the moving human body can also affect the
	range obtainable.
!	Please test all devices before final installation because transmission quality can often be
	improved by moving the components slightly.
!	Turn off the transmitter and receiver if the system is not in use.
!	Do not touch the antennas when the system is switched on.
!	Do not place the receiver behind a monitor or TV.
!	To avoid the risk of damage to MicroCam III, use only the supplied power adaptors.
	Don’t place above or near a heat source which may cause the equipment to overheat.

Camera Features

MicroCam IIIMicroCam III Stand

!
!	Microwave ovens can cause interference and diminish the quality of the signal if the
	MicroCam III or Receiver are located close by.
!	Beware of humid locations. Water droplets or spray may damage the units. If condensation
	does occur, do not use until the equipment has dried out.
!	Never paint or attach metallic labels or stickers of any kind.
!	Do not use two MicroCam III systems operating at the same time in the same area. This will
	result in picture interference.
!	Do not cut the DC power cable of the MicroCam III to fit with another power source. This
	may result in damage to the MicroCam III & any unauthorised modifications will void your
	warranty.

9v Battery Adaptor

Camera Power Adaptor

IMPORTANT: Due to the power consumption requirements of this product, we highly recommend the use of a 9 volt battery only for short term portable use.