Swann PNP-150/2D warranty Before You Begin, Troubleshooting Guide, Technical Specifications

Before You Begin

FCC Verification:

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de- signed to provide reasonable protection against harmful interference in a residen- tial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be deter- mined by turning the equipment off and on, the user is encouraged to try to cor- rect the interference by one or more of the following measures:

·Reorient or relocate the receiving antenna

·Increase the separation between the equipment and the receiver

·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

·Consult the dealer or an experienced radio/TV technician for help

IMPORTANT: Prohibition against eavesdropping.

Except for the operations of law enforcement officers conducted under lawful authority, no person shall use, either directly or indirectly, a device operated pursu- ant to the provisions of this Part for the purpose of overhearing or recording the private conversations of others unless such use is authorized by all of the parties engaging in the conversation.

WARNING: Modifications not approved by the party responsible for compliance could void user’s authority to operate the equipment.

IMPORTANT SAFETY INSTRUCTIONS:

·Make sure product is fixed correctly and stable if fastened in place

·Do not operate if wires and terminals are exposed

Troubleshooting Guide

Problem: I can’t see the camera on my TV.

Solution: Ensure the camera is plugged in and the TV or VCR is tuned to the correct input channel.

Problem: When I view my camera at night I only see a bright spot and no image.

Solution: Night Vision will reflect when shining through a window. Move the camera to the other side of the window or another location.

Problem: The BNC Extension Cable will not connect to my TV.

Solution: Connect the BNC to RCA adapter to the end of the Extension Cable and plug into the TV.

Problem: On my Swann DVR, Video Loss appears where my camera should be.

Solution: Check the Extension cable is securely connected to the camera and check the connection is secure on the back of the DVR. Also ensure the camera has power by trying a second power outlet.

Technical Specifications

Video
Image Sensor	1/3” Color Super CMOS
Video Quality	400 TV Lines
Number of Effective Pixels	NTSC: 510 x 492 / PAL: 628 x 582
Minimum Illumination	0 Lux (IR on)
Day/Night Mode	Color during day / switches to B&W night
White Balance	Automatic
Signal / Noise Ratio	> 50dB
Electronic Shutter	1/60 - 1/15,000 NTSC / 1/50 - 1/15,000 PAL
Gain Contr=ol	Automatic
Backlight Compensation	Yes
Lens	6mm
Viewing Angle	53 degrees
Night Vision
Number of Infra-Red LEDs	30
Infra-Red Wavelength	850nm
Night Vision Distance	Up to 30ft / 9m
Infra-Red LED Life	10,000 hours
General
Operating Power	DC 12V
Operating Temperature	-10°C ~ 50°C / 14°F ~ 122°F
Body Construction	ABS Plastic
Dimensions - Camera	5.5” x 2.8” x 2.8” / 140mm x 70mm x 70mm
Dimensions – Stand	4.5” x 2.3” x 2.3”/ 120mm x 60mm x 60mm
Weight – Camera & Stand	0.5lbs / 235g

2 7