MOWER HEIGHT ADJUSTMENT
•Make adjustments while TrailMower is not running.
•There is approximately 1 ½” to 4 ½” of height adjustment.
•Rotate height adjust crank handle(s) in a clockwise direction to lift the mower deck. A
•For best results, see “SUGGESTED PRACTICE” section. Graduated scales are for reference only, not the actual cutter height.
FRONT TO BACK ADJUSTMENT
For best cutting results, the mowing deck should be raised to ¾” higher in the rear.
•Make adjustments while TrailMower is not running.
•Remove bolts from the “L” hitch (H1), (SEE FIGURE FOUR).
•Raise or lower hitch section to obtain proper front to back adjustment.
•Re-install bolts in “L” hitch securely.
TOW HITCH OFFSET
This TrailMower has been designed to operate offset from the center of the tow vehicle or consecutively with another TrailMower, providing additional cutting width. When offsetting the mower do so to the side opposite the discharge of the tow vehicle.
•Swisher recommends if the tow vehicle is equipped with a
•If the tow vehicle is not equipped with a
•To change the offsetting position both
STARTING TO MOW
•Adjust the cutting height.
•Double check vehicle to mower attachment.
•Start mower engine and set throttle to “FAST” for best cutting performance.
•Slowly engage blade clutch lever.
•Carefully mount vehicle and start mowing at a slow travel speed.
STOPPING THE MOWING SESSION
•Bring tow vehicle to a complete stop, shut off engine, and set parking brake.
•Disengage blades.
•Manually shut toggle switch and/or key switch to their “OFF” positions.
•Always remember to remove keys to avoid irresponsible usage. (Electric Start models only)
8