25
Parking Brakes
9The Swisher ZT2460 is equipped with an Automatic Parking
Brake system on each control handle.
9When the control handles are in the out most position the
parking brakes are on.
9Adjustment for the system is located on the ends of the brake
cable at the hydro pan & frame
9Raise the rear wheel off the ground.
9Disengage the hydro to be adjusted with the hydro release
handle at the rear of the unit
9Adjust so that the brake is not on when the handles are in the
operator position. The wheel should turn freely.
9The wheel should not turn when the handle is move to the
engaged or outward position.
9To tighten the brake, turn the adjustment nuts towards the end
of the cable.
9Recheck adjustment with control handle
9Lower unit back to the ground
9Reengage the hydro at the rear of the unit
SERVICE & ADJUSTMENTS
WARNINGWhen it is necessary to raise the mower for
any repair or service, use jackstands to
provide adequate support. DO NOT rely on
hydraulic or mechanical jacks