Syba Tech SY-KVM20050 manual Operation, Hotkey Conguration

Package Contents

TM

1 SY-KVM20050 USB KVM Switch with Attached Cables 1 User Guide

Hardware Requirements

Console · A VGA, SVGA, or Multisync monitor · A USB Keyboard

· A USB Mouse

Computers

The following equipment must be installed on each computer that is to be connected to the system:

· A VGA, SVGA or Multisync video port · A USB Type A port

Hardware Review

2 Port USB Cable KVM Switch

SY-KVM20050

User Guide

		1. Port LEDs
		2. KVM Cables
Specifications and products are subject to		3. Console Ports
		4. Speaker Jack
change without prior notice		5. USB keyboard/Mouse connector
All trade name referenced are the registered		6. Video Connector
	Made in China	7. Speaker Plug
trademark of their respective owners

Hardware Installation

·Before beginning the installation procedure, ensure that all equipment to be connected is powered o￿.

·Unplug power cords of any computers that have the ‘Keyboard Power On’ function. Otherwise, the switch will receive power from the computer

·To prevent damage to your equipment, make sure that all the devices are properly grounded

Installing your new SY-KVM20050 involves the following steps:

1.Plug your keyboard, monitor, and mouse into their ports on the SY-KVM20050. The keyboard and mouse ports are labeled with an icon to distinguish them.

Note: When using a wireless composite keyboard and mouse, its USB cable must plug into the SY-KVM20050 keyboard port for the Hotkeys to function.

2.Plug your speakers into the SY-KVM20050’s speaker jack. Note: This step is optional

3.Plug the USB, video, and speaker connectors of the attached KVM cables into their respective ports on the computers you are installing.

4.Turn on the power to the computers.

Note: The SY-KVM20050’s Power On default is to link to the ￿rst computer you turn on.

Operation

Hotkey Port Selection

All hotkey port switches begin with tapping the Crtl key twice. [Crtl] [Crtl]

Invokes Auto Scan Mode

Starts Auto Scan. Press and release the [Left shift] key, and then press the [Right shift] key.

[Left shift] [Right shift]

Cancel Auto Scan Mode

Press and release the [ESC] or [Space] key

Scan Interval

Sets the Auto Scan interval to n second intervals - where n is a number from 1 – 4.

[Left shift] [Right shift] [n]

Note: The n stands for the number of seconds that the focus dwells on a port before switching to the other one. Replace the n with a number between 1 and 4 when entering this hotkey combination. (See the table, below.)

Scan Interval Table

n	Secs.
1	3 secs.
2	5 secs.(Default)
3	10 secs.
4	20 secs.

Hotkey Con￿guration

Invoking Hotkey Mode [Ctrl] + [F12] . There are 3 Steps:

1.Press and hold down the [Ctrl]

2.Press and release [12]

3.Release the [Ctrl]

After invoking Hotkey Mode, key in one of the following keys to perform the corresponding function:

Key		Function
F1		Sets the PC Compatible keyboard operating platform.
F2		Sets the Mac keyboard operating platform.
F3		Sets the Sun keyboard operating platform.
[ESC] or		Cancel operation platform setting
[Space]
R [Enter]	Resets the Hotkey settings to their default status.

Troubleshooting

	Symptom		Possible Cause		Action
	Keyboard	Keyboard / Mouse		Unplug the keyboard / mouse from the Console
and/or		needs to be reset.		Keyboard Port, then plug it back in.
Mouse Not		Hotkey sequence		Resend the Hotkey command - press and
Responding		input incorrectly.
				release each key in the sequence individually.
		Switch needs to be		Turn off the computers; wait 5 seconds; turn the
		reset.		computers back on.
	Video	Resolution and/or
	Problems	Refresh rate set too		Select a lower resolution and/or bandwidth.
		high.

Keyboard Emulation Mapping

The USB 101/104 key keyboard can emulate the functions of the Sun or Mac keyboard. The corresponding functions are shown in the table below.

Sun Keyboard

Note: When using [Ctrl] combinations, press and release the Ctrl key, then press and release the activation key.

PC Keyboard	Sun Keyboard
[Ctrl] [T]	Stop
[Ctrl] [F2]	Again
[Ctrl] [F3]	Props
[Ctrl] [F4]	Undo
[Ctrl] [F5]	Front
[Ctrl] [F6]	Copy
[Ctrl] [F7]	Open
[Ctrl] [F8]	Paste
[Ctrl] [F9]	Find
[Ctrl] [F10]	Cut
[Ctrl] [1]
[Ctrl] [2]
[Ctrl] [3]
[Ctrl] [4]
[Ctrl] [H]	Help

Mac Keyboard

Note: When using key combinations, press and release the ￿rst key, then press and release the second key.

PC Keyboard	Mac Keyboard
[Shift]	Shift
[Ctrl]	Ctrl
[Win]
[Ctrl] [1]
[Ctrl] [2]
[Ctrl] [3]
[Ctrl] [4]
[Alt]	L Alt/Option
[Prt_Sc]	F13
[Scroll Lock]	F14
[Desktop Menu]	=
[Enter]	Return
[Back Space]	Delete
[Ins]	Help
[Ctrl] [Win]	F15

Specifications

	Function		SY-KVM20050
Computer Connections			2
Port Selection			Hotkey
	Console	Keyboard	1 x USB Type A Female (Black)
		Video	1 x HDB-15 Female (Blue)
	Ports	Mouse	1 x USB Type A Female (Black)
		Speaker	1 x Mini Stereo Jack Female (Green)
Connectors		Keyboard/ Mouse	2 x USB Type A Male (Black)
	KVM
		Video	2 x HDB-15 Male (Blue)
	Ports
		Speaker	2 x Mini Stereo Plug Male (Green)
LEDs	Selected		2 (Green)
Cable	Computers		4 ft (1.2 m)
Length
Emulation	Keyboard/ Mouse		USB
Video			2048 x 1536; DDC2B
Scan Interval			5 Seconds
	Operating Temp.		32 ~ 122°F (0 ~ 50°C)
Environment	Storage Temp.		-4 ~ 140°F (-20 ~ 60°C)
	Humidity		0-80% RH, Non-condensing
	Housing		Plastic
Physical	Weight		0.86 lb (0.39 kg)
Properties	Dimensions		3.11 x 2.60 x 1.02 in
	(L x W x H)		(7.90 x 6.60 x 2.60 cm)