18
EN
CHANNEL SELECTION
You can select the channel by using either [CH K/L]
or Channel number buttons.How to select the
channel in each way is shown below.
1Using [CH K/L]or Channel number buttons,
and pressing [ENTER].
• Using [CH K/L], change the channel.
•
When you select a channel press the channel
number you want to view with Channel number
buttons.The selected channel will be displayed.
• When selecting analog channel 12
• When selecting digital channel 12-1
Be sure to press [–] before entering the
minor-channel number.
•
If the channel broadcasts NTSC and ATSC both
and you don't press [–], then you will receive the
NTSC channel only.The moment you press [–],
the memorized smallest digital channel will be
displayed.
• When you press [CH RETURN], the previously
selected channel will be selected.
• Same operation is available with [CHANNEL
K/L]on the top panel of the main unit.
About minor-channel broadcasting:
There may be different programs being broad-
cast on minor-channels through a single chan-
nel from ATSC.You can watch each minor-
channel program being broadcast by selecting
one of the minor-channels.
NOTE:
In the DTV broadcasting, one channel sometimes broadcasts
multiple programs depending on the air time.In this case, the
main channel is called major channel and the minor-channel
is called minor channel.
1 1
2
-
ENTER
1 2
ENTER
ENTER
POWER SLEEP
AUDIO
STILL
SETUP
BACK
SCREEN
MODE
INFO
CH RETURN
MUTE
VOL. CH
1 2 3
4 5 6
7 8 9
-
0
INPUT
SELECT
ENTER
CH RETURN
MUTE
CH
1 2 3
4 5 6
7 8 9
-
0
VOLUME ADJUSTMENT
This section describes how to adjust the volume
when viewing TV.The MUTE function, which is use-
ful when you have a visitor or a phone call, will be
also described.
1Using [VOL. X/Y]or [MUTE]
[VOL.X/Y]
•
You can adjust the audio volume with [VOL. X/Y].
• The volume bar is displayed at the bottom of
the screen when adjusting the volume.
• Same operation is available with [VOLUME
X/Y]on the top panel of the main unit.
• The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
• Press [MUTE] on the remote control to mute
the sound.
• To release the Mute status, press [MUTE]
again or press [VOL.X/Y].
• “Mute” is displayed on the screen for a few sec-
onds.
Mute
Volume 20
BACK
INFO
CH RETURN
MUTE
VOL. CH
MUTE
VOL.
NOTE:
“No signal” will appear on the screen after the minor-
channel broadcast is over.
You will need to change the channel to continue
watching another TV program.
: changes automatically
: change manually by pressing [CH / ]
on your remote control.
CH4-1
18:00
18:30
19:00
19:30
20:00
CH4-2
CH4-1
CH4-1
CH4-3
No signal No signal
CH4-3
ATSC
CH4
NTSC
No signal
CH4-2CH4-1
No signal
WATCHING TV