12
EN
INITIAL SETTINGS
This section describes the initial settings when you
first turn on the power after purchase.The initial
setting items are shown below.
• LANGUAGE SELECTION
You can select the menu language displayed on
the screen among English, Spanish and French.
• AUTOSCAN(TV/DTV)
(Select “Air”when using antenna)
The channels broadcasted in TV and DTV are
automatically scanned and memorized.Only the
receivable channels in the area where this TV is
used will be memorized.
• AUTOSCAN(CATV)
(Select “Cable”when using RF/Incoming cable)
The channels broadcasted in CATV are automati-
cally scanned and memorized.
1After making all the necessary connections, turn
on this TV.
2Press [POWER].Initial Setup menu will appear.
• This operation may take a few moments.
• If Initial Setup menu does not appear press
and hold [ENTER] for 3 seconds, initial setup
will appear then proceed to step 3.If you have
already turned on this TV before, refer to “LAN-
GUAGE SELECTION”on page 17 to select a
language for the on-screen displays.
ENTER
POWER SLEEP
AUDIO
STILL
SETUP
BACK
SCREEN
MODE
INFO
1 2 3
4 5 6
7 8 9
-
0
INPUT
SELECT
ENTER
POWER
3Select your language using [K /L], press
[ENTER].
When you first turn on the power, the following
screen is displayed.
The Antenna Confirmation will be displayed in
the selected language after you press [ENTER].
4Select destination of ANT.IN jack using [K /L],
press [ENTER].
5Autoscan will start automatically.
• When scanning is completed, the smallest
memorized channel will be displayed.
NOTES:
• The initial Autoscan function can be executed for either “Air”
or “Cable”only once. When you change the connection
(Air/Cable), set the “Autoscan”again. (Refer to page 13.)
• When the scanning is not completed, Helpful Hint will be
displayed every time you turn on the power.If you have
previously registered channels when this screen appears
you can select a channel with number buttons.
• Support hotline is provided on the front page of this
manual.
Initial Setup
Initial Setup
Now the system is scanning for channels,please wait.
Exit
SETUP
5%
Analog channels 1ch
Digital channels 0ch
Initial Setup
Initial Setup
Air
Cable
Select Enter Exit
SETUP
Back
BACK
ENTER
Make sure the antenna is connected to "ANT. IN" jack.
Select the destination of "ANT. IN" jack.
Air
Cable Or
ANT. IN
Initial Setup
Initial Setup
Select the language used for setup.
Elija idioma de preparación.
Sélectionner langue écran config.
Select Enter Exit
SETUP
English
Español
Français
ENTER
INITIAL SETTINGS
No channel is registered.
Press and hold "ENTER" key for 3 seconds.
Contact support hotline provided on manual or back of unit.
Sin canal registrado.
Mantenga oprimida la tecla "ENTER" durante 3 segundos.
Llame teléfono de apoyo en manual o atrás de TV.
Pas de chaîne consign.
Maintenir la touche "ENTER" pressée 3 secondes.
Contacter numero d'urgence dans manuel ou arrière appareil.
2-0