www.sylvania.com/encelium
ENCELIUM™ Energy Management System
Energy Control Unit
Wiring and Installation Manual
Overview
The Energy Control Unit (ECU) is a gateway that interfaces to both IT equipment (servers, LAN, etc) and field bus devices (luminaire controllers, sensors, wall switches, etc). Communication with IT equipment and other ECUs is achieved using the Ethernet port. Additionally, two USB 2.0 ports are provided for data transfer and
The ECU provides operating power together with communication signals via GreenBus IITM to the various
field bus devices of the system via eight GreenBus IITM communication channels.
The ECU makes each device addressable via GreenBus IITM (e.g. each light fixture can be individually dimmed and turned on/off). Devices will obtain their addresses during the commissioning process and no actions are required during installation.
The following model(s) are available:
Indoor Locations:
Important Safeguards
When using electrical equipment, basic safety precautions should always be followed including the following:
•READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
•Do not let power supply cords touch hot surfaces.
•Do not mount near gas or electric heaters.
•Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
•The use of accessory equipment is not recommended by OSRAM Sylvania as it may cause an unsafe condition.
•Do not use this equipment for other than the intended use.
SAVE THESE INSTRUCTIONS
Page 1 of 4
OSRAM and Logo are registered trademarks of OSRAM GmbH.
ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA, Inc
GreenBus II are trademarks of OSRAM SYLVANIA, Inc.
SEE THE WORLD IN A NEW LIGHT is a registered trademark of OSRAM SYLVANIA, Inc.
