Sylvania LD370SC8 S owner manual Watching TV, 5Channel Selection, 5Still Mode, 5Sleep Timer

WATCHING TV

5Channel Selection

Select channels by pressing [CH K/L] or [the Number buttons].

•To select the memorized channels, use [CH K/L] or [the Number buttons].

•To select the non-memorized channels use [the Number buttons].

To Use [the Number buttons]

TV

- When selecting analog channel 12

DTV

-When selecting digital channel 12-1

Be sure to press [–]before entering the minor channel number.

•Press [CH RETURN] to return to the previously viewed channel.

About digital TV broadcasting:

With its high definition broadcast, digital broadcasting far surpasses analog broadcasting in both its picture and sound quality.

What is the minor channel?

By using high compression technology, digital broadcasting offers a service that enables multiple signals to send simultaneously.

Therefore, you can select more than one program per major channel since digital broadcasting technology distinguishes between multiple channels broadcast by a single network.

5Volume Adjustment	INTRODUCTION
This section describes how to adjust the volume. The mute function, which
turns the sound off and on, is also described.

Use [VOL. X/Y] to adjust the audio volume.

	Volume 20	CONNECTION
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear
in a few seconds.		INITIAL
Press [MUTE ] to turn off and on the sound.
		SETTING
	Mute

•“Mute” is displayed on the TV screen for a few seconds.

Press [MUTE	WATCHINGTV
	] again or [VOL. X/Y] to recover the

original volume.

5Still Mode

You can freeze the image shown on the TV screen.

Press [PAUSE F] to pause the image shown on the		OPTIONAL
screen.
		SETTING
	Pause
• The sound output will not be paused.
• If no signal is detected or protected signal is received
during still mode, the image remains paused and the		OPERATING
sound output will be muted.
• The still function will be released after 5 minutes.
To cancel still mode, press any button except [POWER].		DVD

NTSC (analog mode) [Air Time]

	18:00
	18:30
CH4	19:00
	19:30
	20:00
	20:30

ATSC (digital mode)

CH4 No signal No signal

CH4

(high definition TV)

CH4	CH4-1	No signal
CH4	No signal	CH4-2
CH4	CH4-1	CH4-2

5Sleep Timer
The sleep timer can be set to automatically turn off the unit after an			SETTING
incremental period of time.
1 Press [SLEEP] to set the sleep timer.
			DVD
	Sleep	Off
• Sleep timer display appears on the TV screen.			TROUBLESHOOTING
2 Press [SLEEP] repeatedly to change the amount of time
until shut off.

major channel minor channel

: change automatically

: change manually by using [CH K/ L]

Note:

•“No Signal” will appear on the TV screen after the minor channel broadcast is over.

	Sleep 120min.
• You can set your unit to turn off after a set period of
time (from 30 to 120 minutes).		INFORMATION
• Each press of [SLEEP] will increase the time by 30
minutes.
• After set up, the sleep timer display can be called up
for checking by pressing [SLEEP].

15

EN