Sylvania SRT2232X Cabinet Disassembly Instructions, Disassembly Flowchart, Disassembly Method

CABINET DISASSEMBLY INSTRUCTIONS

1. Disassembly Flowchart

This flowchart indicates the disassembly steps for the cabinet parts, and the CBA in order to gain access to item(s) to be serviced. When reassembling, follow the steps in reverse order. Bend, route and dress the cables as they were.

Caution !

When removing the CRT, be sure to discharge the Anode Lead of the CRT with the CRT Ground Wire before removing the Anode Cap.

[1]Rear Cabinet

[2]CRT CBA

Note:

(1)Order of steps in procedure. When reassembling, follow the steps in reverse order.These numbers are also used as the Identification (location) No. of parts in figures.

(2)Parts to be removed or installed.

(3)Fig. No. showing procedure of part location

(4)Identification of part to be removed, unhooked, un- locked, released, unplugged, unclamped, or des- oldered.

S=Screw, P=Spring, L=Locking Tab, CN=Con- nector, *=Unhook, Unlock, Release, Unplug, or Desolder

2(S-2) = two Screws (S-2)

(5)Refer to the following "Reference Notes in the Table."

[3]Main CBA

[4]CRT

2.Disassembly Method

				Removal
Step/
	Part		Fig.	Remove/*unlock/
Loc. No.
				release/unplug/	Note
			No
				unclamp/desolder
[1]	Rear		1,2	7(S-1), 1(S-2),	1
	Cabinet			3(S-4)
[2]	CRT CBA		4,5	CN1501	2
				CN571, CN801,
[3]	Main CBA		3,5	CN802, CN691,	3
				Anode Cap
[4]	CRT		4	4(S-3)	4
↓	↓		↓	↓	↓
(1)	(2)	(3)		(4)	(5)

Reference Notes in the Table

1.Removal of the Rear Cabinet. Remove screws 7(S-1), 1(S-2) and 3(S-4) then slide the Rear Cab- inet backward.

2.Removal of the CRT CBA. Disconnect CN1501 then pull the CRT CBA backward.

Caution !

Discharge the Anode Lead of the CRT with the CRT Ground Wire before removing the Anode Cap.

3.Removal of the Main CBA. First, disconnect CN571, CN801, CN802, and CN691 on the Main CBA. Second, remove Anode Cap. then slide the Main CBA backward.

4.Removal of the CRT. Remove screws 4(S-3) then slide the CRT backward.

4-1 L6650DC