Sylvania SSR90V4 owner manual VCR/DVD recorder Switching, Editing

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Before you

Install two AA batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1 2 3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disas- semble batteries.

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Use within the operating range and angle as shown.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

Within about 23feet (7m)

60˚

Remote control

start Connections Getting started Recording Playing discs

VCR/DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which com- ponent you wish to operate with the OUTPUT SELECT button.

Editing

VCR MODE

Press the VCR button on the remote control. (Verify that the VCR SELECT indicator is lit.)

DVD MODE

Press the DVD button on the remote control. (Verify that the DVD SELECT indicator is lit.)

Note

•Pressing only the OUTPUT SELECT button on the front panel DOES NOT switch the mode of the remote control.You MUST select the cor- rect mode on the remote control.

•Pressing the SETUP or the TIMER PROG. button switches the unit to the DVD mode.

OUTPUT SELECT button

		POWER REC SPEED AUDIO			OPEN/CLOSE
		.@/:	ABC	DEF
		1	2	3
		GHI	JKL	MNO	CH
		4	5	6
		PQRS	TUV	WXYZ	VIDEO/TV
		7	8	9
	VCR button		SPACE		SLOW
			0
		DISPLAY	VCR	DVD	PAUSE
	DVD button
	OUTPUT SELECT		PLAY
			STOP
VCR	DVD	REC/OTR	SETUP		TIMER PROG.
	DVD SELECT	REC MONITOR		ENTER
	indicator	MENU/LIST	TOP MENU		RETURN
	VCR SELECT	CLEAR/C-RESET	ZOOM	SKIP	SKIP
		SEARCH	CM SKIP
	indicator	MODE

Changing the SETUP menu VCR functions Others Español

9