Maintenance
It is recommended that the detector be removed from its mounting base to facilitate easier cleaning. The detector is cleaned as follows:
NOTE: Before removing the detector, notify the proper authorities that the smoke detector system is undergoing maintenance and will temporarily be out of service. Disable the zone or system undergo- ing maintenance to prevent unwanted alarms.
1.Remove the detector cover by placing a small bladed screwdriver in the side slot of the detector cover, twist- ing it slightly until the cover can be turned counterclock- wise for removal.
2.Vacuum the screen carefully without removing it. If fur- ther cleaning is required continue with Step 3, otherwise skip to Step 6.
3.Remove the screen by pulling it straight out (see Figure 2). Vacuum the inside.
4.Clean the vaned chamber piece by vacuuming or blow- ing out dust and particles.
5.To replace the screen, orient it so that the arrow on top aligns with the test module socket of the detector. Carefully push the screen onto the base making sure it fits tightly to the chamber.
6.Replace the cover by gently rotating it clockwise until it locks in place.
7.Reinstall the detector.
8.Notify the proper authorities that the system is back on line.
Please refer to insert for the Limitations of Fire Alarm Systems
System Sensor warrants its enclosed smoke detector to be free from defects in materials and workmanship under normal use and service for a period of three years from date of manufacture. System Sensor makes no other express warranty for this smoke detector. No agent, representative, dealer, or employee of the Company has the authority to increase or alter the obligations or limitations of this Warranty. The Company’s obliga- tion of this Warranty shall be limited to the repair or replacement of any part of the smoke detector which is found to be defective in materials or workmanship under normal use and service during the three year period commencing with the date of manufacture. After phoning System Sensor’s toll free number
Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174.
Please include a note describing the malfunction and suspected cause of failure. The Company shall not be obligated to repair or replace units which are found to be defective because of damage, unreasonable use, modifications, or alterations occurring after the date of manufacture. In no case shall the Company be liable for any consequential or incidental damages for breach of this or any other Warranty, expressed or implied whatsoever, even if the loss or damage is caused by the Company’s neg- ligence or fault. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
4 | ||
|
| ©2004 System Sensor |
