34
Trouble-shooting
Many problems have a simple cause and a correspon-
dingly simple solution. The following section describes a
few difficul ties you may encounter, and the measure s
you need to take to cure them.
If you find it impossible to solve a problem with the help
of these notes please ask your authorised specialis t
dealer for advice.
Problem: No output signal, or seriously distorted
signal at the loudspeakers.
Cause: Short-circuit at the loudspeaker cables;
e.g. through stray wire strands at the ter-
minal clamps, or mechanical damage to
the cables.
Remedy: Check lou dspeaker cables and terminals
carefully, twist wire en ds neatly (conductor
sleeves can also be used); be sure to
replace damaged cables!
Problem: Flat sound image, insufficient bass res-
ponse.
Cause: The loudspeaker cables ar e connected
with reversed polarity.
Remedy: Check the speaker connections at the
loudspeakers and at the am plifier’s spea-
ker term inals, referring to the wiring dia-
gram; correct if necessary.
Problem:Excessive or booming bass response.
Cause: The loudspeaker is set up too close to the
wall or in one corner of the room.
Remedy: Maintain a minim um distance of 50 cm to
the side walls, or change the setting o f the
„BASS“ switch on the back of the speaker.
Cause: Sympathetic vibration of floor, room walls
or furniture.
Remedy: Use spik es or damping elements to suit
your installation. Ask your specialist
dealer for advice.
Problem:No treble response from the T CI 1 RE or
TCI 2 E.
Cause: The high voltage for the electrostatic treble
units is not present.
Remedy: Move the mains switch on th e back of the
speaker to the „ON“ position.