Before You Begin
Getting Started
Quick Setup
The Tact 2.2X Quick Setup wizard is designed to help both the first time and experienced user perform complete room correction and create nine correction presets quickly and easily. To run the Quick Setup successfully you will need to know your speaker configuration, your loudspeakers lower
1 - Connect the RS 232 “Input” jack on the back of the
NOTE: These instructions assume that you have already established communication between the RCS 2.2X and the Room Correction Software on your computer. See page 32.
2 - If you have one or more TacT M2150/S2150 digital amplifiers connect them to the RCS 2.2X. Please make sure that a unique address has been set for each device. For further instructions please refer to your M2150/S2150 owner’s manual.
3 - Make sure that the
CAUTION: To avoid damage through static discharge, we strongly recommend to turn off the
4 - Turn your
5 - Set the Mode setting for the
6 - Turn on your computer and start the
7 - Enable your microphone if you are using the Tact microphone that came with your unit. To enable or disable the microphone click on the “mic:” display window found on the main screen with your left mouse button to toggle its setting. When the microphone number is displayed it is enabled. If you have not installed your microphone please see page 31 for instructions.
Start the Quick Setup by selecting the yellow “Quick Setup” button located on the
The