6.Rotate the upper housing until it lines up with the lower housing. Make sure the edges of the two hous- ings mate all the way around the GHOST (Figure 6) and then pull the black attachment handles down over their attachment posts (Figure 7).
7.If desired, secure the GHOST to the top of the joists.
8.Plug the connector from the GHOST into the Control Box. Plug the Control Box into an unswitched, grounded receptacle.
9.Install the ceiling grille (screws provided).
10.Check the unit for proper operation:
Turn the unit on - it will take 30 seconds for the doors to open.
Fan starts - the fan should start and run smoothly.
Be sure at least one window is open when the fan is operating.
Figure 6.
Figure 7.
wiring
WARNING: State and local electrical codes may require that the GHOST be installed by a licensed electrician. Check with your local code officials before installing. Be sure to turn off power before wiring the GHOST Whole House fan.
specificationS
Electrical: |
|
|
Voltage | 115 VAC 60Hz |
|
Power | (High Speed) 450 Watts |
|
| (Low Speed) 340 Watts |
|
|
|
|
Air Flow | High Speed 3400 CFM |
|
| Low Speed 1900 CFM |
|
|
|
|
Operation | 30 second Door Cycle Time |
|
|
| |
|
|
|
Insulation Value of | MODEL GH: |
|
Closed Doors | MODEL GHD: |
|
|
|
|
|
|
|
Weights | Whole House Ventilator: 48 Lbs. |
|
| Shipping: 67 Lbs. |
|
Top Housing |
|
|
26 1/4” long x 26” W x 14 1/8’ H |
| |
|
|
|
Lower Housing | 25 7/8” long” x 29 1/2” W |
|
| x 13 5/8” H |
|
|
|
|
