Manuals / Tanaka / Lawn and Garden / Trimmer

Tanaka manual Fueling, Owner’s Manual, AST-210,AST-5000, Operating procedures Fuel Fig

Models: AST-210 AST-5000

1 21

Download 21 pages 43.11 Kb

Page 9

4.Operating procedures Fuel (Fig. 2-1)

AST-210,AST-5000	Owner’s Manual
	Owner’s Manual

4.Operating procedures Fuel (Fig. 2-1)

WARNING!

The trimmer is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel.

Fuel

•Always use branded 89 octane unleaded gasoline.

•Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil (B)), only for the state of California at 50:1.

•Never use multi-grade oil (10 W/30) or waste oil.

•Always mix fuel and oil in a separate clean container.

Always start by filling half the amount of fuel, which is to be used. Then add the whole amount of oil. Mix (shake) the fuel mixture.

Add the remaining amount of fuel.

Mix (shake) the fuel-mix thoroughly before filling the fuel tank.

Fueling

WARNING!

•Always shut off the engine before refueling.

•Slowly open the fuel tank, when filling up with fuel, so that possible over-pressure disappears.

•Tighten the fuel cap carefully, after fueling.

•Always move the trimmer at least 3 m (10 ft.) from the fueling area before starting.

Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the tank.

Make sure that the fuel is well mixed by shaking the container, before fueling.

www.tanakapowerequipment.com

8

custsvc@tanaka-ism.com

Image 9

Tanaka manual Fueling, Owner’s Manual, AST-210,AST-5000, Operating procedures Fuel Fig, custsvc@tanaka-ism.com

Contents

AST-210 AUTO-START TRIMMERSSupplier To The Outdoor Power Equipment Industry Owner’s ManualOwner’s Manual Before using this unitAST-210,AST-5000 Check that the cutting equipment is correctly assembled and adjustedAST-210,AST-5000 Be careful of throwncustsvc@tanaka-ism.com Owner’s Manual 1. What is what ?AST-210,AST-5000 custsvc@tanaka-ism.comOperator Safety 2. Warnings and safety instructionsTool Safety Fuel SafetyOwner’s Manual 3. Assembly proceduresAST-210,AST-5000 Drive shaft to engine Fig.1-1Throttle wire/stop cord AST-210 Installation of handle Fig. 1-2, 2BInstallation of blade guard Fig. 1-6, 6B, 6C Owner’s ManualInstallation of the cutting head Installation of cutting equipment Fig.1-9Owner’s Manual AST-210,AST-5000Fueling Fuel4. Operating procedures Fuel Fig Owner’s ManualOwner’s Manual Starting Fig. 2-2, 2BAST-210,AST-5000 custsvc@tanaka-ism.comAST-210,AST-5000 Battery charging procedureOptionalAST-250 Stopping Fig. 2-2BStopping Fig Cutting Fig. 2-4, 4B, 4C, 4DOwner’s Manual AST-210,AST-5000Carburetor adjustment Fig. 3-1, 1B 5. MaintenanceIdle speed adjustment T Cleaning the air filterOwner’s Manual Fuel Filter Fig. 3-2BAST-210,AST-5000 Spark plug FigAngle transmission Fig. 3-5B Flexible drive shaft FigBlade Fig Owner’s ManualBattery Removal AST-5000 Owner’s ManualAST-210,AST-5000 Daily maintenance Maintenance scheduleWeekly maintenance Monthly maintenanceSpark arrestor 6. OptionalInstallation of free disk set optional Fig. 4-1, 1 B Owner’s ManualOwner’s Manual 7. SpecificationsAST-210,AST-5000 conditions with the following time distribution ½ idling, ½ racingAST-210,AST-5000 Owner’s Manualcustsvc@tanaka-ism.com en adelanteCutting Attachments for Tanaka Trimmers and Brushcutters IMPORTANT NOTICEAST-210,AST-5000 THIS INFORMATION IS FOR THE US AND CANADIAN MARKETS ONLY