Administrator Settings
43
3.8 Standby The system will automatically go to Standby mode when it is not in use. In standby mode, the
screen(s) are black. It is however still possible to receive incoming calls.
How to enter standby mode manually:
Select Standby from the menu and select Standby Now, or
Press the End Call button on the remote control twice.
How to exit standby mode:
When the system is in standby, pick up the remote control, or press any of its keys to
activate the system again.
The standby mode of the system should be enabled if the system is to be left idle.
Note! Standby is not activated by switching off the power to the monitor(s) (some systems
come with monitors that are not possible to switch off.).
If the system is set for Use screen as Local PC monitor, see Control Panel – General - Screen
Settings, the Standby mode will be disabled when the codec detects a video signal from the
PC. If the PC video signal is not detected, the standby mode will be re-enabled.
It is possible to postpone the system from entering standby mode for 1 hour or 3 hours, see Delay
Standby for 1 hour and Delay Standby for 3 hours.