Tandy 16-175 Using Your TV, Troubleshooting, Backlight, Using An Earphone, Picture, but no sound

Models: 16-175

1 4
Download 4 pages 48.96 Kb
Page 3
Image 3
Using Your TV

16-175.fm Page 3 Tuesday, July 20, 1999 9:53 AM

Using Your TV

1.Extend the rod antenna.

2.Set OFF/VHF/UHF to VHF or UHF. The TV starts scanning and stops at the next active channel in the selected band.

3.Press TUNING < or > to tune to a differ- ent channel. The tuning line on the screen aligns with the selected channel number below the screen.

4.Adjust VOLUME.

5.Adjust BRIGHT for the desired bright- ness. The brighness also changes with the screen’s angle.

Notes:

If desired, fold out the stand on the back of the TV and lean the TV on a flat surface at a convenient angle.

If reception is poor, adjust the length or angle of the rod antenna. If inside a metal or concrete building, moving closer to a window might improve reception.

BACKLIGHT

In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red in color. This is not a malfunction. Nor- mal operation resumes after a short while.

USING AN EARPHONE

For private listening, you can connect an op- tional earphone with a 1/8-inch plug to the EAR jack. This automatically mutes the built- in speaker.

Cautions:

Set VOLUME to the lowest setting before you begin listening. Then adjust the volume to a comfortable level.

Do not wear an earphone while operat- ing a vehicle or riding a bicycle. This can cause a traffic hazard and is illegal in some areas.

Troubleshooting

Color too light or no color.

Extend the antenna and set it to the proper angle.

No picture and no sound.

Be sure the batteries are fresh and inserted correctly.

Be sure any adapter is correctly con- nected.

No picture and noisy sound.

• Adjust the antenna.

Picture, but no sound.

Adjust VOLUME.

Be sure you disconnected the ear- phone.

Sound, but the picture is all white, dark, or blurred.

Adjust BRIGHT.

Be sure the batteries are fresh.

Picture is not clear (moves up or down, disappears periodically, becomes fuzzy or blurred, is doubled, etc.), but the TV has sound.

Be sure the antenna is fully extended. Adjust the antenna’s angle and direc- tions for the best reception.

Be sure the batteries are fresh.

Be sure the TV is away from appliances that might cause interference.

In locations with poor reception, it might be impossible to get a clear picture or any picture at all. Change the location.

If you are unable to locate the problem, take the TV to your local RadioShack store for assistance.

3

Page 3
Image 3
Tandy 16-175 manual Using Your TV, Troubleshooting, Backlight, Using An Earphone, Color too light or no color