Important Features of the BF-572

•The BF-572 allows you to measure both weight and body fat per- centage simultaneously as easily as stepping on a scale.

•The BF-572 stores results over time and displays them graphically so that users can track their progress.

•The BF-572 can be set for a Adult, Athlete or Child, Female or Male, increasing the accuracy of the reading.

•Personal data (Adult/Athlete/Child, Female/Male and Height) can be stored in the memory of the unit for up to four people.

•Weight-Only Key provides quick weight readings.

•The unit emits a helpful “beep” when activated, and also at various stages in the programming and measuring processes. Listen for these sounds which will prompt you to step on the unit, look at your reading(s), or confirm a setting.

Selecting the Weight Mode (lb, kg or st-lb)

The BF-572 can measure weight in three different modes: lb (pounds), kg (kilograms) or st-lb (British stone-pounds). The default setting (the setting at which Tanita products are shipped) is lb. If you would like to change that setting, or if at any point another setting has been inadvertently entered, follow these steps:

Press and simultaneously. Release the buttons, the display will flash all three weight modes at the same time. Press to cycle through each weight mode until just the mode that you require

is displayed. Then press . The unit will beep twice in short suc- cession, and the display screen will flash to confirm your selection and store it in memory.

Note: If weight mode is set to pounds or stone-pounds, the height programming mode will be automatically set to feet and inches. Similarly, if kilograms is selected, height will be automatically set to centimeters.

Preparations Before Use

Inserting the Batteries

Locate the battery cover on the back of the measuring platform. Press the tab to release the cover as shown and insert the supplied AA-size batteries as indicated.

Direction of the batteries.

Open as shown.

Note: Be sure that the polarity of the batteries is set properly. If the batteries are incorrectly positioned, the fluid may leak and damage floors. If you do not intend to use this unit for a long period of time, it is advisable to remove the batteries before storage.

Positioning the Unit

To ensure safe and accurate measurement, place the unit on a hard, flat surface where there is minimal vibration.

Note: To avoid possible injury, do not step on the edge of the platform.

Attaching the Support Feet

If (and only if) you would like to place the unit on carpet, insert the supplied support feet into the holes at the four corners on the bottom of the measuring platform.

Automatic Shut-Down Function

The automatic shut-down function shuts off the power automatically in the following cases:

•If you interrupt the measurement process. The power will shut down automatically within 10 to 30 seconds, depending upon the type of operation.

•If an extraordinary weight is applied to the platform.

•If you make a mistake during measurement or a key or button operation.

•During programming, if you do not touch any of the keys or but- tons within 60 seconds.

•After you have completed the measuring process.

Note: Do not use the unit on any carpeting that is more than 0.8” (20 mm) in thickness.

Do not use the support feet on hard, flat surfaces, as the unit may tip over.

4