GB
TAKING WEIGHT AND BODY FAT READINGS
1. Select Personal Data Number
Press the Up button turn on. Use the Up/Down buttons to select your Personal data number. Press the Set button to confirm.
(Release the key within 3 seconds or the display will show “Error”.) The unit will beep and the display will show the programmed data.
The unit will beep again and the display will show “0.0”.
Now step onto the platform.
Note:
•If you step onto the platform before “0.0” appears the display will show “Error” and you will not obtain a reading. Furthermore, if you do not step onto the measuring platform within about 60 seconds after “0.0” appears, the power is
•When using the “Up” button to turn the unit on, the personal data number last used will appear first.
•Numbers that are not
2.Get Your Readings
Your weight will be shown first. Continue to stand on the platform. “00000” will appear on the display and disappear one by one from left to right.
The readings will be shown alternately 3 times as follows:
Note:Do not step off until Body Fat % is shown.
Weight | Body fat percentage | Total body water percentage |
UNDERSTANDING YOUR READING
GB
PROGRAMMING THE GUEST MODE
Guest mode allows you to programme the unit for a
Press 
button to activate the unit. Then follow the steps: Set Age, Select Female or Male, and Specify Height.
Note : If you step onto the platform before “0.0” appears the display will show “Error”
and you will not obtain a reading.
TAKING WEIGHT MEASUREMENT ONLY
Select Weight-Only Key
Press the
TROUBLESHOOTING
If the following problems occur …then…
•A wrong weight format appears followed by kg, lb, or
Refer to “Switching the Weight Mode” on p.4.
•“Lo” appears on the display, or all the data appears and immediately
disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the accuracy of your measurements. Change all the batteries at the same time with new batteries.
Under Healthy Over Obese
*Note: If you select Athlete mode, the unit will not display the Healthy Range Indicator. Athletes may have a lower body fat range based on their particular sport or activity.
(Range of user age is between
Healthy Range Indicator (Standard Adults only*)
Your body fat monitor/scale automatically compares your body fat reading to the Healthy Body Fat Range chart.
Following your body fat percentage reading, a black bar will flash along the bottom of the display, identifying where you fall within the Body Fat Ranges for your age and gender. For example, if the squares appear above (0) area your range is within the Healthy Range – if they appear over
: Underfat; below the healthy body fat range. Increased risk for health problems. |
(0): Healthy; within the healthy body fat percentage range for your age/gender.
(+): Overfat; above the healthy range. Increased risk for health problems. (++) : Obese; high above the healthy body fat range. Greatly increased risk
of
Note: Your settings will not be erased from the memory when you remove the batteries.
•“Error” appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
•The Body Fat Percentage measurement does not appear or
after the weight is measured.
Your personal data has not been programmed. Follow the steps on p.6.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the measuring platform.
•“OL” appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
•“Error FAT%” appears while measuring.
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
7 | 8 |
