Tannoy CMS601 DC warranty

CMS601 DC

Architectural specifications The Ceiling Monitor System shall consist of a 165mm (6.50") full range, point source, constant directivity Dual ConcentricTM transducer and passive fre- quency dividing network mounted in a vented, injection moulded, paintable front baffle in UL94V-0 ABS material.

The back can in both PI (pre-install) & BM (blind-mount variants) shall be constructed of zinc plated steel. A recessed termination box shall be integrated with the back can, a removable locking connector with screw terminals for secure wire termination with "loop through" facility shall be provided. Strain relief will be provided by a clamping mechanism for use with plenum rated cable or conduit.

For prewiring the PI (pre-install) back can is provided with conduit knockouts (19mm / 22mm / 28mm, 0.75" / 0.87" / 1.14"). A safety ring is located on the rear of the back can for a load bearing safety bond.

Performance of the Ceiling Monitor System shall meet or exceed the following criteria: The system shall have a conical coverage pattern of 111degrees (1kHz to 6kHz). Frequency response measured on axis shall be 50Hz - 30kHz (-10dB from rated sensitivity, measured in an IEC baffle in an anechoic chamber) with no equalization. Sensitivity shall be 91dB (1W @ 1m). Long term power handling capacity as defined in EIA-426B test shall be 80W, recommended amplifier power 160W. Dynamic high frequency protection is provided for occasional overpowering. The nominal system impedance shall be 8 Ohms (in low impedance setting).

The Ceiling Monitor System shall be equipped with a 60W high performance line transformer for use in 70.7 or 100 Volt distributed audio systems with 60, 30, 15, 7.5* Watt taps available. An easily accessible rotary switch located on the front baffle shall be available for selecting transformer and low impedance settings. A weather resistant perforated steel grille covers the transducer and switch.

Two support rails and one C-Ring shall be included with the ceiling monitor system. Bezel diameter 280mm (11.02")

BM	Front of ceiling to rear of back can 258mm (10.16"), Front of ceiling to top of safety loop 275.5mm (10.84")
PI	Front of ceiling surface to rear of speaker unit 99.40mm (3.91"), Front of accessory back can bezel to top of safety loop 168.50mm (6.60")

The Ceiling Monitor System shall be the...CMS601 DC. *70 Volt only

Tannoy United Kingdom

Tannoy North America

Tannoy Deutschland

Tannoy France

T:00 44 (0) 1236 420199

T:00 1 (519) 745 1158

T:00 49 (180) 1111 881

T:00 33 (0)1 7036 7473

E:enquiries@tannoy.com

E:inquiries@tannoyna.com

E:anfragen@tannoy.com

E:ventes@tannoy.com

Tannoy adopts a policy of continuous improvement and product specification is subject to change CMS601 DC data file // issue 1.06 // 10.01.08