![](/images/new-backgrounds/1109606/1096069x1.webp)
Using the RF Mouse
Installing the Battery
1Remove the battery cover from the bottom of the mouse by pressing the battery cover tab and siding it off.
2Insert the supplied battery, making sure that the positive (+) and negative
3Slide the battery cover back into position until it “clicks” firmly into place.
The optical sensor, located on the bottom of the mouse, glows red.
WARNINGS: When replacing the battery, if you are using the mouse with the charger base, you must use
If you are using the mouse without the charger base, you may use alkaline or other
Setting the Radio Frequency Channel
Before you establish a link between the optical mouse and its receiver, you must set the radio frequency channel. To do this, slide the channel switch to A or B on both the mouse and the receiver. For the mouse, the switch is located inside the battery compartment. For the receiver, the switch is located directly opposite the USB connector.
NOTE: The optical mouse and its receiver must be set to the same channel to function properly.
5