100W Auto/Air®
Mobile Power Inverter
Trouble Shooting | Safety Precautions |
Problem: No Power Output, indicator not ON Possible causes and suggestions:
•The Car’s battery is low (<11.5Vdc) or defective Start the engine to recharge or replace the car’s battery if needed. Disconnect the input cable before starting the car’s engine to minimize power surge. If such a case occurs, reconnect the cable to resume normal operation.
•Connection cable is not secured
Reconnect the cables and make sure all plugs are secured.
•Equipment being operated draws too much power Reduce load to continuous 100 watts or below and use equipment with starting surge power within inverter capability.
•Inverter in thermal shut down condition
Allow the inverter to cool down. Ensure there is ventilation around the unit.
• Inverter Fuse blown
Unplug the power cable and replace the fuse following fuse replacement instruction.
•Automotive Fuse for Cigarette Lighter Blown Check and replace the fuse for your car's cigarette lighter following the instructions in your car's service manual.
Problem: Low Output Voltage
Possible cause and suggestions:
• Inverter is overloaded
Reduce load to continuous 100 watts or below to maintain regulation.
• Input voltage below 11.5Vdc
Keep input voltage above 12Vdc to maintain regulation. Replace the car’s battery if needed.
Technical Support
For technical questions, please visit:
US | Internet: | www.targus.com/support.asp |
Australia | Internet: | www.targus.com/au |
| Email: | infoaust@targus.com |
New Zealand | Telephone: | |
|
| |
Telephone:
•This device outputs 120 Volts of electricity just as a wall socket does. Exercise extreme care that nothing comes in contact with the AC connector.
•Do not use in the presence of water or moisture.
•Do not use or place the inverter near flammable materials or any locations that may accumulate flammable fumes or gases.
•To avoid potential property damage, do not leave this inverter or any device operating unattended in vehicle.
•Always disconnect the input to the inverter when it is not in use.
•Disconnect the input cable before starting your car to minimize surges.
•Reverse polarity connection will result in a blown fuse and may cause permanent damage to the inverter (Damage due to reversed polarity is not covered by our warranty).
•Do not connect to AC distribution wiring.
•Improper use of this inverter can cause personal injury, property damage, and or loss of life.
•This is not a toy. Keep away from reach of children.
•Indoor use only.
•The maximum
Product Registration
Targus recommends that you register your Targus accessory shortly after purchasing it. To register your Targus accessory, go to: http://www.targus.com/registration.asp You will need to provide your full name, email address, phone number, and company information (if applicable).
Warranty
Targus warrants this product to be free from defects in materials and workmanship for one year. If your Targus accessory is found to be defective within that time, we will promptly repair or replace it. This warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under no conditions is Targus liable for loss of, or damage to a computer; nor loss of, or damage to, programs, records, or data; nor any consequential or incidental damages, even if Targus has been informed of their possibility. This warranty does not affect your statutory rights.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Statement
Tested to Comply
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna
•Increase the separation between the equipment and receiver
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not authorized by the party responsible for compliance could void the user’s authority to operate this product
Quick Start Guide
Features and specifications subject to change without notice. © 2006, Targus Group International, Inc. and Targus, Inc., Anaheim, CA 92806 USA. | APV10US / |
