14 TASCAM 322
WARNING : Make all connections with power off.
1. Refer to the diagram above, and interconnect
multiple 322s through the EXT CONTROL OUT
and IN and the CASCADE OUTPUT and DECK 1
INPUT connectors.
2. Switch on power to each 322.
3. Make the following switch settings :
“OFF/SLV/MSTR switch to MSTR on one 322, and
SLV on all the other 322s (any but only one 322 can
be designated as the master).
“REV MODE switch to ä on each 322.
4. Insert the source tape into deck 1 of the master 322,
and target tapes into all the other decks in use.
Suggestion : There is no problem if there are
slaves into which no tape is inserted.
5. If the reverse PLAY LED is blinking on any slaves,
press the Á button on deck 2 of the master unit.
If the reverse PLAY LED is blinking on deck 1 of
the master unit, press the Á on that deck.
Bear in mind that, in a multiple-322 system, the
transport control buttons on deck 1 of the master
unit are independent from all the other decks, while
the buttons on deck 2 of the master unit have effect
on decks 1 and 2 of every slave unit
6. If need be, rewind the source tape to the beginning
with the REW button on deck 1 of the master.
Pressing the REW button on deck 2 of the master
rewinds all the target tapes to their beginnings.
7. Press the DUB STDBY NORM or Hl SPEED button
on the master unit, as required. For an explanation,
see steps 4 and 8 under the heading Dubbing From
Deck 1 Onto deck 2.
Upon pressing either DUB STDBY button, deck 1
of the master goes into Play Ready mode, and all
the other decks go into Record Ready mode.
If you hav e pressed a wrong b utton or changed your
mind and want to switch NORM to HI SPEED, or
vice versa, first press STOP on deck 2 of the master.
Then, press HI SPEED or NORM, as required.
8. Press the SYNC REVERSE button on the master
unit.
The LED above the button will light steadily, while
the same LED on all the slaves will start blinking.
Simultaneous Dubbing onto Multiple Cassettes
322 MASTER
322 SLAVE-1
322 SLAVE-2
Multiple-322 System Operation