Tascam 322 - page 16

16 TASCAM 322

9. Adjust the INPUT control on deck 2 of the master

so the meter reading is around 0 dB. Balance the

left and right input levels with the REC BAL

control.

10. Set the DOLBY NR switch on deck 2 of the master

to the desired position.

All the slave decks conﬁgure themselves to the

level and balance on deck 2 of the master. Settings

on the individual decks are overridden.

11. To start recording, press the Á button on deck 2

of the master.

If the tape on deck 2 of the master reaches the end

of the forward side before any tapes on the slaves,

recording continues on these tapes up to the end of

their forward sides.

You can interrupt recording on all the decks by

pressing STOP on deck 2 of the master.

12. When all the tapes reach the end of their forward

sides, hold down RECORD and press PAUSE on

deck 2 of the master to put all the decks into

Record Ready mode.

13. Press the Ó button on deck 2 of the master so that

all the tapes are ready for recording on their

reverse sides.

14. To continue to record, press the Ó button once