USING CDS (BB-1000CD only)

Inserting a disc

1Insert the disc halfway with the label facing forward as shown in the following illustration.

2Push the disc in further until it is pulled in automat- ically when almost hidden.

CAUTION

•• You cannot insert a disc when the unit is turned OFF.

•• If a disc sticks, for example becoming difficult to push, pull out the disc and press the EJECT [ø] key, and then try to load it again. Do not force the disc in. Doing so could damage the unit or the disc.

•• If a disc other than an audio CD is inserted, or a disc is inserted backwards, it will be automatically ejected when CD is selected.

3 – Preparation

Ejecting a disc

Press the EJECT [ø] key. After the disc is ejected halfway, pull it out by holding its edge.

NOTE

•• You cannot eject a disc when the unit is turned OFF.

•• A disc can only be ejected when the Home screen is open.

•• A disc cannot be ejected when an SD card file is being played.

•• A finalization confirmation message appears before ejecting a disc that has not yet been finalized. (See “Finalizing a CD-R/RW so that it can be played in other CD players (BB-1000CD only)” on page 29.)

Forcing disc ejection

If pressing the EJECT [ø] key does not eject the disc because the CD drive is malfunctioning, for example, you can force a disc to eject by using the force disc ejection hole.

To force a disc to eject, turn the unit’s power OFF and follow the procedures below

1Prepare a long pin such as a stretched paper clip.

2Insert the pin into the force disc ejection hole and push it in several times.

3Pull the disc out by hand after it is ejected halfway.

CAUTION

Never try to force a disc to eject using the force disc ejection hole when the unit’s power is ON.

TASCAM BB-1000CD/BB-800 19